3D Systems CubePro Manual - Page 10

Browse online or download pdf Manual for 3D Printers 3D Systems CubePro. 3D Systems CubePro 11 pages. Unjamming extruder
Also for 3D Systems CubePro: Original Instructions Manual (18 pages), Original Instructions Manual (12 pages)

Print Page
3D Systems CubePro Manual
 Check jet's loom and position of thermocouple as shown:
 Install the jet back into the extruder drive. Level the jets and check the check Z gap as shown starting
on page 62 of the user guide. Disconnect head loom from the breakout board to avoid damaging the
components while levelling the jets. There will be a warning message on the screen. This can be
ignored for now. Replace the head loom connector when finished and reinstall the breakout board
using the two 2.5 mm Hex screws.
 Connect all looms back to sensor PCB and breakout board according to their markings.