ARPEGE SECURITY TC-5500S Operation Manual - Page 7

Browse online or download pdf Operation Manual for Cash Counter ARPEGE SECURITY TC-5500S. ARPEGE SECURITY TC-5500S 10 pages. Vacuum banknote counter

Print Page

 Step 2: Re-press the ACC button after the counting mode selected. (The

lower part of LED display will show the number of "0" for starting the

counting processing.)

 Step 3: The incorrect counting result will not be totaled if there is

problem in counting process. The CLEAR key can be used to delete the

last counting result if the user doesn't want it to be totaled.

※ The Self-Diagnosis Test Function

Function: This function is designed for checking the system's: 1)

Vacuum Pressure, 2) LED display, 3) Spindle Sets, 4) Counter

Sets, 5) Motors banknote counting and feeding process.

Step 1: User need to block the holes of Spindle Sets by adhesive plastic



tape and select 0 function key after the machine is power-on. The

Self-Diagnosis Test will operate automatically. User can press the

same key again to turn off this function.

Step 2: During testing mode, user can check the following five parts:



1) The Vacuum Pressure: The air pressure under counting cannot be

lesser than 480 cm/Hg. If it is lesser than this, then the machine

might not count the notes properly because of insufficient pressure.

User needs to check the vacuum system, including Vacuum Pump,

Pipe System and Filters. Most of time the operator just needs to

clean the filters of Pump (E007 / E008) and Suction Head (A002)

only.

2) The LED Display: If the numbers from 1-999 cannot be showed

properly on the screen, then please replace it with a new display.

3) The Spindle Set: It is driven by the motors to supply the vacuum

suction for banknote counting.

4) The Counter Set: User needs to block the holes on Spindle Set with

adhesive plastic tape. Then if the numbers from 1 to 999 are

displayed on the screen, it means Counter Set work properly.

5) The Motors: Checking Motor1 is to make sure the banknote gripper

is working properly; Checking Motor 2 is to make sure the spindle

set is driven by the motor properly.

Caution:

Test Mode is effective only after the machine is just power-On. You should re-start

the machine again if you need to use the Test Mode after any counting.