Array Solutions Four Square User Manual - Page 4

Browse online or download pdf User Manual for Control Systems Array Solutions Four Square. Array Solutions Four Square 10 pages. Array controller
Also for Array Solutions Four Square: User Manual (12 pages)

Print Page

Place the controller relay box in the geometric center of the array. Use the U-bolt mounting

bracket provided to mount the box onto a ground rod, pipe, or tower leg. Feed each vertical with

¼ wavelength of 70 ohm feedline. The galvanized U - bolt can accept a water pipe driven into the

ground as the mounting post. It has a 1.5 inch (38 mm) inside diameter. Mount it on the edge of

the cover as shown on the picture below and tighten the U-bolt against the pipe with the

connectors facing down. For added lightning protection you can drive in a ground rod and ground

the relay box to the ground rod as well.

Set up your verticals into a square spaced ¼ WL apart from each other; we will define the square

as follows. The antenna ports are marked from 1 to 4 with four directions to be set up as follows

and cabled to the controller in the center.

The above diagram indicates verticals (●), Antenna number (1-4), and Directions

Antenna Feed lines-

Build your 4 antenna feed lines from RG-11 or other 75 ohm coax and

make them ¼ wave-length long. You will need to use "foam" coax with a velocity factor greater

www.arraysolutions.com

2611 N. Beltline Rd.,Ste 109

Sunnyvale, TX, 75182, USA

● 2

● 3

● 1

● 4

[email protected]

Phone: +1 214 954 7140

Four Square Manual, ver. 2.1

August 21 2017