3D Upfitters LulzBot Mini 2 R1 Installation Manual - Page 11

Browse online or download pdf Installation Manual for 3D Printers 3D Upfitters LulzBot Mini 2 R1. 3D Upfitters LulzBot Mini 2 R1 18 pages. Enclosure kit

Print Page

attaching to the ﬁlter and back of the enclosure using M4 cap head 30mm or 40mm screws

depending on the depth of the particular fan.

The air ﬁlter should look like this after being attached.

Note that its easier to insert the screws from the

inside, and put the nuts next to the ﬁlter housing.

If you didn't purchase an air ﬁlter you should just

see a fan, as shown to the right. As with the ﬁlter,

make sure the fan is blowing air out of the

enclosure.

7. Attach Top

First move the partially assembled enclosure, the Front, Left Side, and Back, and place

them around the LulzBot Mini 2 as pictured below.