AmeriWater 00850300 Installatie- en bedieningshandleiding - Pagina 4

Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} AmeriWater 00850300. AmeriWater 00850300 7 pagina's. Alarm package for good quality,ro

Pagina afdrukken

1.0 Theory of Operation

The 00850300 alarm monitor package is designed to let users know when

something is not functioning properly with the water equipment. This alarm will

warn the user by illuminating a red light and sounding an audible alarm, indicating

that some limit has been exceeded.

This alarm has a green "GOOD QUALITY" light to let you know at a glance that the

system is operating correctly. The property to be monitored has been chosen

during the original purchase of this equipment. This system can monitor:

R/O Alarm; this will warn the user that the measured conductivity of the

water generated by the RO is higher than what has been determined to

be appropriate by the Facility Director, and has been programmed into

the RO controller.

2.0 Installation

Locate the alarm panel outside the water room at an easily accessible

and highly visual position on the wall, within 6' of a 120-volt outlet. Notice

that 100' of wire is provided to interface with the RO controller.

CAUTION:

Disconnect ALL power supplies to the all the equipment, prior to

wiring the alarm panel or electrical shock could result.

WARNING:

Be sure jumpers on the auxiliary board on the RO's controller

are jumpered between J3 & J4 ONLY. If not, damage to the alarm panel or RO

controller will result.

Connect a wire to L1, Relay 2 in the RO and to terminal 61 in the alarm

panel.

Connect a wire to L2, Relay 2 on the RO+ and to terminal 63 in the alarm

panel. If multiple RO's are being connected, wire them in a parallel

manner. (Refer to wiring diagram)

3.0 Start-up

Plug the alarm panel into a 120-volt outlet,

and then apply power to all other equipment.

Make sure the alarm panel operates correctly by

creating faults with the equipment connected to

the alarm panel and then clearing them.

P/N 98-0163

REV A