Ametek Land NIR-2K Installatiehandleiding - Pagina 16

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Ametek Land NIR-2K. Ametek Land NIR-2K 20 pagina's.

Thermal Imaging Camera

Fig. 4-5

Fig. 4-7

4.2 Using an alternative Power Supply Unit

If you do not have a TRACO Power Supply Unit, you can use a 24 V DC supply to power

the NIR-656 / NIR-2K Thermal Imager.

You will need to connect the camera to the power supply via a cable, available from

AMETEK Land:

Two lengths of cable are available:

Length: 20 m / 66 ft, Part Nº 814614

Length: 50 m / 164 ft, Part Nº 814615

Minimum bend radius: 50 mm / 2 in

Recommended mounting method: Cable fixings/Conduit (Insulate as necessary)

IP Rating: IP65

Cable connections:

Black - connect to + 24 Volts

White - connect to 0 Volts

Fig. 4-6

Strip back the mains cable wires to

the appropriate lengths and connect

them to the Input connector terminals

(Fig. 4-5) as per the wiring schedule

below:

Pin 1 = Live

Pin 2 = Neutral

Pin 3 = N/C

E = Earth

The mains input cable connector is now

ready for re-assembly and connection

to the Power Supply Unit (Fig. 4-6).

Reassemble the mains input connector.

Attach the mains cable to the Input

connector of the Power Supply Unit

(Fig. 4-7).

You can now connect the TRACO Power

Supply Unit to the NIR-656 / NIR-2K

Thermal Imager camera via the pre-

wired power cable assemblies.

NIR-656 / NIR-2K

Installation Guide