Canon EF100mm f/2 USM Instructies - Pagina 2
Blader online of download pdf Instructies voor {categorie_naam} Canon EF100mm f/2 USM. Canon EF100mm f/2 USM 2 pagina's. Ef lenses
Ook voor Canon EF100mm f/2 USM: Instructies (2 pagina's), Instructie (15 pagina's), Instructies (2 pagina's), Gebruikershandleiding (5 pagina's)
Pagina afdrukken
8. Hood
The hood can keep unwanted light out of the lens, and also
protects the lens from rain, snow, and dust. Engage the hood
attachment tabs on the lens with the tabs on the hood and
turn the hood in the direction of the arrow to secure it to the
lens.
[Bayonet type]
EF20mm f/2.8 USM, EF28mm f/1.8 USM and EF50mm
f/1.4 USM (sold separately), and EF24mm f/1.4L USM and
EF35mm f/1.4L USM (supplied with the lens).
To fit the hood on the EF20mm f/2.8 USM, EF24mm f/1.4L
USM, EF28mm f/1.8 USM or EF35mm f/1.4L USM, align
the hood's attachment position mark with the red dot on the
front of the lens, then turn the hood clockwise until the lens's
red dot is aligned with the hood's stop position mark
When attaching or detaching the hood, grasp the base of the
hood to turn it. To prevent deformation, do not grasp the rim
of the hood to turn it.
Though there is no red dot on the hood for the EF50mm f/1.4
USM (ES-71II), the attachment procedure is the same.
• Part of the picture may be blocked if the hood is not
attached properly.
• The hood can be reverse-mounted on the lens for storage.
[Clip-on type]
EF85mm f/1.8 USM, EF100mm f/2 USM (sold separately)
Press the buttons on both sides of the hood to attach as
illustrated
.
[Cut-in type]
Fixed type EF14mm f/2.8L USM
①
The hood and lens are a single unit.
Pull-out type EF200mm f/2.8L USM
②
Pull the hood out from the front of the lens to use
Specifications
Angle of view
Diagonal
Vertical
EF14mm f/2.8L USM
114°
81°
EF20mm f/2.8 USM
94°
62°
EF24mm f/1.4L USM
84°
53°
EF28mm f/1.8 USM
75°
46°
EF35mm f/1.4L USM
63°
38°
EF50mm f/1.4 USM
46°
27°
EF85mm f/1.8 USM
28°30'
16°
EF100mm f/2 USM
24°
14°
EF200mm f/2.8L USM
12°
7°
*1 Built-in gelatine filter holder
*2 Built-in
CT1-7538-004
The lens length is measured from the mount surface to the
front end of the lens. Add 21.5 mm when including the lens
cap and dust cap.
The size and weight listed are for the lens only, except as
indicated.
Product specifications and appearance are subject to
change without notice.
.
❾
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. If such changes or modifications should be made, you could be
required to stop operation of the equipment.
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generated, uses and can radiate radio
.
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled
"Digital Apparatus", ICES-003 of the Industry Canada.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques (de la classe B) prescrites dans le Règlement
sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.
Lens
Minimum
Max. magnification and field of view
construction
aperture
Horizontal
0.10X/246 × 375 mm (9.7" × 14.8")
104°
10-14
22
84°
9-11
22
0.14X/176 × 264 mm (6.9" × 10.4")
0.16X/150 × 227 mm (5.9" × 8.9")
74°
9-11
22
65°
9-10
22
0.18X/139 × 212 mm (5.5" × 8.3")
54°
9-11
22
0.18X/136 × 206 mm (5.4" × 8.1")
40°
6-7
22
0.15X/164 × 249 mm (6.5" × 9.8")
24°
7-9
22
0.13X/191 × 287 mm (7.5" × 11.3")
0.14X/175 × 262 mm (6.9" × 10.3")
20°
6-8
22
10°
7-9
32
0.16X/152 × 226 mm (6" × 8.9")
❾
●
Min. focusing
Filter diameter
distance
<Usable number>
0.25 m/0.82 ft.
*1 <3>
0.25 m/0.82 ft.
72 mm <1>
0.25 m/0.82 ft.
77 mm <1>
0.25 m/0.82 ft.
58 mm <1>
0.3 m/0.98 ft.
72 mm <1>
0.45 m/1.48 ft.
58 mm <2>
0.85 m/2.79 ft.
58 mm <1>
0.9 m/2.95 ft.
58 mm <2>
1.5 m/4.92 ft.
72 mm <2>
© CANON INC. 2006
●
●
Hood
Max. diameter and length
77 × 89 mm (3.0" × 3.5")
*2
560 g/19.6 oz.
EW-75II
77.5 × 70.6 mm (3.1" × 2.8")
405 g/14.2 oz.
83.5 × 77.4 mm (3.3" × 3.1")
EW-83DII
550 g/19.4 oz.
EW-63II
73.6 × 55.6 mm (2.9" × 2.2")
310 g/10.9 oz.
EW-78C
79 × 86 mm (3.1" × 3.4")
580 g/20.5 oz.
ES-71II
73.8 × 50.5 mm (2.9" × 2.0")
290 g/10.2 oz.
ET-65III
75 × 71.5 mm (3.0" × 2.8")
425 g/14.9 oz.
75 × 73.5 mm (3.0" × 2.9")
ET-65III
460 g/16.1 oz.
*2
83 × 136.2 mm (3.3" × 5.4")
790 g/27.7 oz.
Weight
Case
LP1016
LP1214
LP1214
LP814
LP1214
LP1014
LP1014
LP1014
LH-D18
2006.9.1