Amprobe ROBIN KMP7010 Gebruikershandleiding - Pagina 15
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Amprobe ROBIN KMP7010. Amprobe ROBIN KMP7010 16 pagina's. Ground resistance tester
Pagina afdrukken
MAINTENANCE AND REPAIR
If there appears to be a malfunction during the operation of the meter, the
following steps should be performed in order to isolate the cause of the
problem.
1. Check the battery. Replace the battery immediately when the symbol
"
" appears on the LCD.
2. Review the operating instructions for possible mistakes in operating
procedure.
Except for the replacement of the battery, repair of the meter should be
performed only by a Factory Authorized Service Center or by other qualified
instrument service personnel. The front panel and case can be cleaned with
a mild solution of detergent and water. Apply sparingly with a soft cloth and
allow to dry completely before using. Do not use aromatic hydrocarbons,
Gasoline or chlorinated solvents for cleaning.
Battery Replacement
Replace the batteries immediately after the low battery indicator appears on
the screen. Follow the steps below to replace the batteries:
1. Turn the rotary switch to OFF position
2. Remove the screws from the battery cover and open the battery cover
3. Remove the batteries and replace with 6 new 1.5V Alkaline Batteries
(AA). Pay attention to the polarity signs in the battery compartment.
4. Put the battery cover back and re-fasten the screw.
10