amsbio Ozilla AMS.E4002GD Snelstarthandleiding - Pagina 3

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} amsbio Ozilla AMS.E4002GD. amsbio Ozilla AMS.E4002GD 6 pagina's.

Pagina afdrukken
section ??? below on how to access saved detector values.
The detector has a power saving function where it will go into a low power usage mode after 30 seconds of idle time. When this
•
happens, the screen will noticeably dim. Press any key to re-activate the detector.
II. Charging the Battery
The Ozilla Ozone Gas Detector Pro uses a rechargeable polymer battery with long life capabilities. Upon receipt, we recommend
charging the instrument for to full capacity.
The battery can be charged with either the provided wall adapter (100-240V, 50/60Hz) and USB cable, or by plugging the USB cable into a
computer USB port. When the detector is plugged in, a blue light will indicate the battery is charging.
When the battery is fully charged, the light will turn to green.
NOTE: the battery charge indicator in the top right of the screen will show a full battery during the charging process even if battery is
partially charged.
The Ozilla Ozone Gas Detector Pro will take about 5 hours to charge from empty; it will run continuously for many hours on a fully-charged
battery; standby time with the pump shut off is approximately 18 hours.
I. Instrument Screen Layout and Buttons
Refer to Figure 1 on the right
Position
Symbol
Function or Description
1
NA
Gas inlet port
2
NA
Temperature and humidity sensor
3
NA
Light bar indicators
4
Up button
5
"Back"
Back button
6
Down button
7
Power button
8
Run or stop detector pump
RUN
STOP
9
OK
Select Button
10
NA
Exhaust port
11
NA
Calibration adaptor
A
NA
Current date indicator
B
NA
Current time indicator
C
NA
Ozone level readout
D
Pump indicator (spins when pump is on)
E
Battery charge level indicator
Ozilla® Ozone Gas Detector Pro
10
1
2
A
B
C
3
4
5
6
7
Figure 1: detector layout, front.
11
D
E
8
9