Electrolux 1458528 Gebruikershandleiding - Pagina 11
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Electrolux 1458528. Electrolux 1458528 30 pagina's. Side by side refrigeration
Pagina afdrukken
Installing your Ice and Water Filter
Step 16
Remove ice cream shelf (in freezer) to access and switch on
ice maker
ICE MAKER ON OFF SWITCH
ICE MAKER ON OFF SWITCH
OFF
ON
OFF
ON
TEST
FOR SERVICE
USE ONLY.
HOLD DOWN
FOR 15 SECS.
Step 17
After 24 hours remove ice bin and dispose of first few
batches of ice to ensure that impurities have been flushed
from the system.
TEST
FOR SERVICE
USE ONLY.
HOLD DOWN
FOR 15 SECS.
electrolux side by side refrigeration ice and water installation 7
Tips and useful information
Ensure that taps are turned off when replacing and
fitting filters. Remember to turn the taps back on
when filter fitting is complete.
Ensure that the water pressure has been checked
prior to installation as high or low water pressure can
cause problems with the Ice & Water dispenser. Water
pressure problems can be easily rectified by your
qualified installer.
Always fit filter as per manufacturer's instructions,
paying special attention to water flow direction.
If you need to replace water tube, only use
approved water quality piping that meets the
pressure requirements.
Do not allow the water tubing to become kinked
or wrapped under the refrigerator when moving the
refrigerator back into position.
Make sure your refrigerator is level to avoid uneven
ice cubes.
After installation, run the water dispenser for a few
minutes to ensure that all air bubbles have been
purged from the tubing. Dripping may occur if air
bubbles remain in the tube.
Replace filter at suggested intervals to avoid water/ice
reduction and irregularities in taste.
Remove and clean ice bin once a month, discarding
unused ice cubes. This will ensure fresh, clean ice and
smooth operation of your ice maker.
Clean and empty the dispenser drip tray regularly to
avoid overflow.
As the water/ice cut off is not instant, leave glass
under dispenser briefly until water or ice has stopped
flowing to avoid spills.
Always place ice in glass before filling with water to
avoid splashing.