Andersen 400 Series Snelstarthandleiding - Pagina 4

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Andersen 400 Series. Andersen 400 Series 6 pagina's. Lock mechanism
Ook voor Andersen 400 Series: Installatie- en verwijderingshandleiding (2 pagina's), Aanpassing (4 pagina's), Handleiding wijzigen (2 pagina's)

Andersen 400 Series Snelstarthandleiding
2. Attach Non-Reinforced Mullion Clips
• Place Non-Reinforced Mullion Clips into groove
between inside stops along side jambs. Locate clips
3" from top, 3" from bottom and one at center
between check rails. Equally space remaining two
clips between check rail and top and bottom clip.
• Make sure units are flush at ends.
• Using Non-Reinforced Mullion Clips as a guide, drill
into Inside stops using a 3/32" drill bit.
• Secure Non-Reinforced Mullion Clips using four
1-3/8" flat head screws per clip.
3. Attach Sill Gusset Plate
• Place Sill Gusset Plate on bottom of sill, formed
edge over sill, centering at mullion joint.
• Align Sill Gusset Plate edge with Sill and secure
with 1" screws as shown. DO NOT insert screws in
the outermost holes (Sill Gusset Tabs) on formed
section of Sill Gusset Plate.
Sill Gusset Tabs
Sill Gusset Tabs can be bent
down and secured to sill plate
after unit has been installed. Sill
Gusset Tabs provide additional
support to joined unit.
Non-Reinforced Joining Guide (Vertical)
Sill
Check Rail
1" Screws
Sill Gusset
Plate
4
1-3/8" Screws
Check Rail
Non-Reinforced
Mullion Clips
Head
Interior Sides Up
Sill Gusset Tab
Interior Sides Up