Andon KD-322 Bedieningshandleiding - Pagina 6

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Andon KD-322. Andon KD-322 14 pagina's. Semi automatic arm cuff blood pressure monitor

Pagina afdrukken

DN:KD-322-SMSY01 V4.0

SETUP AND OPERATING PROCEDURES

1. BATTERY LOADING

a. Open battery cover at the back of the monitor.

b. Load four "AA" size batteries. Please pay attention to polarity.

c. Close the battery cover.

When LCD shows battery symbol

Rechargeable batteries are not suitable for this monitor.

Remove the batteries if the monitor will not be used for a month or more to avoid

relevant damage of battery leakage.

Avoid the battery fluid to get in your eyes. If it should get in your eyes, immediately

rinse with plenty of clean water and contact a physician.

The monitor, the batteries and the cuff, must be disposed of according to local

regulations at the end of their usage.

2. CONNECTING THE CUFF TO THE MONITOR

Insert the cuff tubing connector into the socket in the left side of the monitor. Make

certain that the connector is completely inserted to avoid air leakage during blood pressure

measurements.

Avoid compression or restriction of the connection tubing during measurement，

which may cause inflation error, or harmful injury due to continuous cuff

APPLYING THE CUFF

a. Pulling the cuff end

packaged like this already), turn it outward (away from your

body) and tighten it and close the Velcro fastener.

b. Place the cuff around a bare arm 1-2cm above the elbow joint.

c. While seated, place palm upside in front of you on a flat surface

such as a desk or table. Position the air tube in the middle of

your arm in line with your middle finger.

d. The cuff should fit comfortably, yet snugly around your arm.

You should be able to insert one finger between your arm and the cuff.

Note:

, replace all batteries with new ones.

through the medal loop (the cuff is

6/14

Operation Guide

pressure.

Template version:1