3M Dynapro ET 3200 Series Installatiehandleiding - Pagina 2
Blader online of download pdf Installatiehandleiding voor {categorie_naam} 3M Dynapro ET 3200 Series. 3M Dynapro ET 3200 Series 3 pagina's.
Ook voor 3M Dynapro ET 3200 Series: Installatiehandleiding (4 pagina's)
Pagina afdrukken
Mounting steps
Important
If installed in a closed or multi-unit rack assembly, the operating
ambient temperature of the rack environment may be greater
than room ambient temperature. Therefore, consideration should
be given to installing the equipment in an environment
compatible with the manufacturer's maximum rated ambient
temperature.
To install the rack adapter in the 19-inch rack, follow
these steps:
1.
To determine where to attach the clip nuts to the rack,
hold the rack adapter in the rack where you want to
mount the ET unit. Fasten the clip nuts on the rack so
that they match the locations of the slots in the sides
of the rack adapter.
The clip nuts will "clip" to the rack. Screws and
washers are not required.
Place the ET unit face down on a padded bench or
2.
other protected surface.
Fit the rack adapter over the back of the ET unit,
3.
against the back of the bezel.
3M Touch Systems Proprietary Information
2
On each of the twelve #10-32 panhead machine
4.
screws, first put on a lock washer and then put on a
flat washer.
5.
Using a No. 2. Phillips screwdriver, attach each screw
(with lock washer and flat washer) through the holes
in the rack adapter and into the back of the bezel of
the ET unit.
Tighten each screw to a torque of 12 inch-pounds.
6.
If your unit requires security screws (available as an
7.
option from 3M Touch Systems), insert them.
8.
Pick up the rack adapter with the ET unit attached and
fit it to the rack. Position it to match the locations of
the clips installed earlier.
Fasten the adapter/ET unit to the clip nuts in the rack
9.
with the eight slotted #10-32 x 5/8-inch countersunk
machine screws with a cup washer on each screw.
10. Connect data and power cables.
Installing the Rack Mount