DSC PC1550 Gebruiksaanwijzing - Pagina 8

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} DSC PC1550. DSC PC1550 17 pagina's. 4 digit master code
Ook voor DSC PC1550: Gebruiksaanwijzing (17 pagina's), Gebruiksaanwijzing (17 pagina's), Gebruiksaanwijzing (9 pagina's), Gebruiksaanwijzing (17 pagina's), Gebruiksaanwijzing (12 pagina's)

[P] Panic

Holding this key down for two seconds causes a steady tone on your siren or

bell if your installer has programmed this key for audible operation. An auxiliary

warning device is also activated if your installer has connected it to your system.

Enter a valid access code to silence the alarm.

Fire Alarm Operations

Alarm

On a fire alarm, the bell/siren will sound pulsing. The digital communicator

transmission is delayed for 30 seconds. If the alarm is not acknowledged within

the 30 second delay, the communicator will transmit to the monitoring station.

Silence

To silence the bell/siren, press the [#] key. If the alarm is silenced and the smoke

detector is not reset, the alarm will resound after 90 seconds.

Reset

To restore the smoke detector(s) to normal, press [ ][7]. If the detector still has

smoke in it, the alarm will resound and the sequence described above will

repeat. If the detector is clear of smoke, the system will return to normal.

NOTE: If you suspect that the communicator has transmitted and there is no fire

condition, call the monitoring station to avoid an unnecessary response. If a fire

condition is apparent, follow your evacuation plan immediately. If the

alarm sounds at night, evacuate immediately.

Testing Your System

It is recommended that you test your system weekly.

NOTE: Perform system tests in the off-peak hours, such as early morning or late

evening.

1. Inform the monitoring station that you are testing your system.

2. Disarm the system ("Ready" light ON).

3. Perform a bell/battery test by pressing [ ][6][Master Code][8]. The signal

will sound for about 2 seconds. If a trouble occurs after the test, press [ ][2]

to view the trouble condition.

4. Activate each sensor in turn (e.g. open a door/window or walk in motion

detector areas). Observe the zone light come ON when the zone is activated.

The zone light will go OFF when the system restores to normal (i.e. door or

window closed).

5. If they are programmed for operation, press the [F], [A], and [P] keys in turn.

The [F] key will sound the bell/siren in a pulsed mode. Enter the access code

to silence the alarm. The [A] key is silent. The [P] key may be programmed

as silent or audible. If the alarm sounds, enter the access code to silence.

6. If the panel has a zone programmed for fire, activation will cause the alarm

signal to sound in a pulsed mode.

CAUTION: Do not use an open flame or burn materials to test a smoke detector.

Contact your alarm installer for information on safe methods to activate a

smoke detector.

7. Should the system fail to operate properly, call your alarm dealer for service.

8. When testing is complete, call and advise the monitoring station.