ansio 1502 Gebruiksaanwijzing - Pagina 7
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} ansio 1502. ansio 1502 8 pagina's.
Pagina afdrukkenSTEPS TO CHANGE THE VOLTAGE SETTING
NOTE: These steps assume that Voltage Selector is set to 220-240V default.
1. Locate the Voltage Selector, recessed inside slot at the back of the Steam iron.
Locate the white open notch in middle of
Voltage Selector (FIGURE 1-A)
2. Use a tool with a fine tip.
3. Carefully insert the tip of the tool into the
white notch. Slide Voltage Selector to
the
left,
towards
(FIGURE 1-B). The iron is now ready for
use in a 120V region.
4. To set unit back to 220V, slide the
Voltage Selector as far to the right
(towards 220-240V label) as possible.
IMPORTANT:
Be sure that Voltage Selector is moved as far to the right as possible for voltage
setting to take effect correctly. Voltage Selector should appear as shown (FIGURE
1-C)
FABRIC IRONING RECOMMENDATIONS
•
For heat-sensitive fabric, cover it with a piece of cotton fabric on top to avoid
damage
Iron clothes with lower heat resistance first.
•
Use an ironing board to avoid any damage to clothing or the iron
•
•
If the iron is too hot, it might leave yellow traces on your clothing. If it
happens, humidify the stains with oxidized water, rinse and dry.
Black or dark clothing should be ironed from the inside out to avoid leaving
•
a trace.
MAINTENANCE
Always unplug when not in use
•
Ensure that all water is removed after use
•
When the iron cools down completely, wipe the main body and the ceramic
•
sole plate with a soft cloth slightly moistened with water.
Do NOT clean the ceramic sole plate with detergents or de-scalers, abrasive
•
or corrosive products.
Do NOT submerge the iron or hold under running water.
•
Wait for the iron to be completely cool before it is stored away.
•
Install the water tank cap to product main body.
•
Contact Customer Support at 0800 080 6781 (Toll Free); +44 207 157 9795
ANSIO 1502
(Feb'23v01)
100-127V
label
7