Auber WS Series Bedienings- en instructiehandleiding - Pagina 14

Blader online of download pdf Bedienings- en instructiehandleiding voor {categorie_naam} Auber WS Series. Auber WS Series 18 pagina's. Precision pid temperature controller

Pagina afdrukken
SET
30
3 sec
Figure 5. Code 155 Parameter setup flow chart
Press and hold SET key for 4 seconds until Parameter Window displayed "LCK".
Release the SET. The display will show "0". Use "+" and "-" keys to adjust the display to
155 (another pass code) and press SET.
Setting the calibration offset. The parameter window will first show "SC "for a second
and then its value, Use "+" and "-" keys to change the setting. When finished, press the
SET again to confirm the change. For example, if the temperature is 1 C too high during
calibration then use "-" to set the value to -1 to offset value.
Setting the output reduction. The parameter window will first show "OUt "for a second
and then its value, Use "+" and "-" keys to change OUt value to your desired limit value
and press SET.
Setting Celsius (C) or Fahrenheit (F). When SET is pressed, the display will show "C-
F" and then its value of either "C" or "F". Press "-" for C or "+" for F.
SET
LC8
155
14
sc
SET
al
SET
fa
SET
oAL
SET
hy
SET
Cool
SET
00t
SET
C-F
SET
C8
SET
0
SET
250
SET
0
SET
0
SET
3
SET
0
SET
100
SET
F
SET
1
SET