Acer B3-A50 Snelstarthandleiding - Pagina 8

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Acer B3-A50. Acer B3-A50 10 pagina's. Tablet computer

Pagina afdrukken

Regulatory Information (PA)

Wireless Adapter Regulatory Information

Use on aircraft

Caution: FCC and FAA regulations prohibit airborne operation of

radiofrequency wireless devices (wireless adapters) because their signals

could interfere with critical interfere with critical aircraft instruments.

The Wireless Adapter and Your Health

The wireless adapter, like other radio devices, emits radio frequency electromagnetic

energy. The level of energy emitted by the wireless adapter, however, is less than the

electromagnetic energy emitted by other wireless devices such as mobile phones.

The wireless adapter operates within the guidelines found in radio frequency safety

standards and recommendations.

These standards and recommendations reflect the consensus of the scientific

community and result from deliberations of panels and committees of scientists who

continually review and interpret the extensive research literature. In some situations

or environments, the use of the wireless adapter may be restricted by the proprietor

of the building or responsible representatives of the applicable organization.

Examples of such situations may include:

- Using the wireless adapter on board airplanes, or

- Using the wireless adapter in any other environment where the risk of interference

with other devices or services is perceived or identified as being harmful.

If you are uncertain of the policy that applies to the use of wireless adapters in a

specific organization or environment (an airport, for example), you are encouraged to

ask for authorization to use the adapter before you turn it on.

USA—FCC and FAA

The FCC with its action in ET Docket 96-8 has adopted a safety standard for human

exposure to radio frequency(RF) electromagnetic energy emitted by FCC certified

equipment. The wireless adapter meets the Human Exposurelimits found in ANSI/

IEEE C95.1, 1992. Proper operation of this radioaccording to the instructions found in

this manual will result in exposure substantially below the FCC'srecommended limits.

The following safety precautions should be observed:

- Do not touch or move antenna while the unit is transmitting or receiving.

- Do not hold any component containing the radio such that the antenna is very close

or touching anyexposed parts of the body, especially the face or eyes, while

transmitting.

- Do not operate the radio or attempt to transmit data unless the antenna is

connected; this behavior maycause damage to the radio.

• Use in specific environments:

- The use of wireless adapters in hazardous locations is limited by the constraints

posed by the safetydirectors of such environments.

- The use of wireless adapters on airplanes is governed by the Federal Aviation

Administration (FAA).

- The use of wireless adapters in hospitals is restricted to the limits set forth by each

hospital.

The product comply with the FCC portable RF exposure limit set forth for an

uncontrolled environment and are safe for intended operation as described in this

manual. The further RF exposure reduction can be achieved if the product can be

kept as far as possible from the user body or set the device to lower output power if

such function is available.

Explosive device proximity warning

Warning: Do not operate a portable transmitter (including this wireless

adapter) near unshielded blastingcaps or in an explosive environment unless

the transmitter has been modified to be qualified for such use.

Interference statement

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy.

If the equipment is not installed and used in accordance with the instructions, the

equipment may cause harmful interference to radio communications. There is no

guarantee, however, that such interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception

(which can be determined by turning the equipment off and on), the user is

encouraged to try to correct the interference by taking one or more of the following

measures:

- Reorient or relocate the receiving antenna of the equipment experiencing the

interference.

- Increase the distance between the wireless adapter and the equipment

experiencing the interference.

- Connect the computer with the wireless adapter to an outlet on a circuit different

from that to which the equipment experiencing the interference is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Caution: Changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate the

equipment.

This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna

or transmitter except in accordance with FCC multi-transmitter product procedures. For product available in

the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.

5 GHz devices only

High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to

5.85 GHz bands. These radar stations can cause interference with and/or damage

this device. No configuration controls are provided for this wireless equipment

allowing any change in the frequency of operations outside the FCC grant of

authorization for US operation according to Part 15.407 of the FCC rules.

FCC RF exposure information (SAR)

This device meets the government's requirements for exposure to radio waves. This

device is designed and manufactured not to exceed the emission limits for exposure

to radio frequency (RF) energy set by the Federal Communications Commission of

the U.S. Government.

The exposure standard for wireless devices employs a unit of measurement known

as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg.

Tests for SAR are conducted using standard operating positions accepted by the

FCC with the device transmitting at its highest certified power level in all tested

frequency bands.

Although the SAR is determined at the highest certified power level, the actual SAR

level of the device while operating can be well below the maximum value. This is

because the device is designed to operate at multiple power levels so as to use only

the poser required to reach the network.

In general, the closer you are to a wireless base station antenna, the lower the power

output. While there may be differences between the SAR levels of various devices

and at various positions, they all meet the government requirement.

The FCC has granted an Equipment Authorization for this device with all reported

SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR

information on this device is on file with the FCC and can be found under the Display

Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID for your device.

Canada – Industry Canada (IC)

This device complies with RSS247 of Industry Canada. Cet appareil se conforme à

RSS247 de Canada d'Industrie.

This device complies with Industry Canada license-exempt RSS standard(s).

Operation is subject to the following two conditions: (1) this device may not cause

interference, and (2) this device must accept any interference, including interference

that may cause undesired operation of the device.

Ce dispositif est conforme a la norme CNR-210 d'Industrie Canada applicable aux

appareils radio exempts de licence. Son fonctionnement est sujet aux deux

conditions suivantes: (1) le dispositif ne doit pas produire de brouillage prejudiciable,

et (2) ce dispositif doit accepter tout brouillage recu, y compris un brouillage

susceptible de provoquer un fonctionnement indesirable.

Radiation Exposure Statement:

The product comply with the Canada portable RF exposure limit set forth for an

uncontrolled environment and are safe for intended operation as described in this

manual.

The further RF exposure reduction can be achieved if the product can be kept as far

as possible from the user body or set the device to lower output power if such

function is available.

Déclaration d'exposition aux radiations : Le produit est conforme aux limites

d'exposition pour les appareils portables RF pour les Etats-Unis et le Canada établies

pour un environnement non contrôlé.

Le produit est sûr pour un fonctionnement tel que décrit dans ce manuel. La

réduction aux expositions RF peut être augmentée si l'appareil peut être conservé

aussi loin que possible du corps de l'utilisateur ou que le dispositif est réglé sur la

puissance de sortie la plus faible si une telle fonction est disponible.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme a la norme NMB-003 du Canada.

"To prevent radio interference to the licensed service, this device is intended to be

operated indoors and away from windows to provide maximum shielding. Equipment

(or its transmit antenna) that is installed outdoors is subject to licensing."

« Pour empêcher que cet appareil cause du brouillage au service faisant l'objet d'une

licence, il doit être utilisé a l'intérieur et devrait être placé loin des fenêtres afin de

fournir un écran de blindage maximal. Si le matériel (ou son antenne d'émission) est

installé à l'extérieur, il doit faire l'objet d'une licence. »

Notice for 5 GHz devices

Caution:

(i) the device for operation in the band 5150 - 5350 MHz is only for indoor use to

reduce the potential for harmful interference to co-channel mobile satellite systems;

(ii) the maximum antenna gain permitted for devices in the bands 5250 - 5350 MHz

and 5470 - 5725 MHz shall comply with the e.i.r.p. limit: and

(iii) the maximum antenna gain permitted for devices in the band 5725 - 5825 MHz

shall comply with the e.i.r.p. limits specified for point-to-point and non point-to-point

operation as appropriate.

(iv) Users should also be advised that high-power radars are allocated as primary

users (i.e. priority users) of the bands 5250 - 5350 MHz and 5650 - 5850 MHz and

that these radars could cause interference and/or damage to LE-LAN devices.

Exposure of humans to RF fields (RSS-102)

The computers employ low gain integral antennas that do not emit RF field in excess

of Health Canada limits for the general population; consult Safety Code 6, obtainable

from Health Canada's Web site at http://www.hc-sc.gc.ca/