Apogee MQ-303 Gebruikershandleiding - Pagina 14

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Apogee MQ-303. Apogee MQ-303 18 pagina's. Quantum meter

MAINTENANCE AND RECALIBRATION

Moisture or debris on the diffuser is a common cause of low readings. The sensor has a domed diffuser and housing for

improved self-cleaning from rainfall, but materials can accumulate on the diffuser (e.g., dust during periods of low rainfall,

salt deposits from evaporation of sea spray or sprinkler irrigation water) and partially block the optical path. Dust or organic

deposits are best removed using water, or window cleaner and a soft cloth or cotton swab. Salt deposits should be dissolved

with vinegar and removed with a soft cloth or cotton swab. Never use an abrasive material or cleaner on the diffuser.

The Clear Sky Calculator (www.clearskycalculator.com) can be used to determine the need for quantum meter recalibration.

It determines PPFD incident on a horizontal surface at any time of day at any location in the world. It is most accurate when

used near solar noon in spring and summer months, where accuracy over multiple clear and unpolluted days is estimated to

be ± 4 % in all climates and locations around the world. For best accuracy, the sky must be completely clear, as reflected

radiation from clouds causes incoming radiation to increase above the value predicted by the clear sky calculator. Measured

values of PPFD can exceed values predicted by the Clear Sky Calculator due to reflection from the sides and edges of clouds.

This reflection increases the incoming radiation. The influence of high clouds typically shows up as spikes above clear sky

values, not a constant offset greater than clear sky values.

To determine recalibration need, input site conditions into the calculator and compare PPFD measurements to calculated

PPFD values for a clear sky. If sensor PPFD measurements over multiple days near solar noon are consistently different than

calculated values (by more than 6 %), the sensor should be cleaned and re-leveled. If PPFD measurements are still different

after a second test, email

recalibration.

Homepage of the Clear Sky Calculator. Two calculators are

available: one for quantum sensors (PPFD) and one for

pyranometers (total shortwave radiation).

to discuss test results and possible return of meter(s) for

Clear Sky Calculator for quantum sensors. Site data are input

in blue cells in middle of page and an estimate of PPFD is

returned on right-hand side of page.