Apogee Black Brant VC Handmatig - Pagina 13

Blader online of download pdf Handmatig voor {categorie_naam} Apogee Black Brant VC. Apogee Black Brant VC 16 pagina's.

Apogee Black Brant VC Handmatig

Recovery System:

… 55. Cut the parachute out around the outer line
so that the parachute is 12" in diameter. Place a
reinforcing ring at each of the corners and using
a pencil or hobby knife, puncture the center of the
ring.
… 56. Cut the shroud lines into three equal sections,
as shown. Then tie the shroud lines through the
reinforcement rings and around the outside of the
parachute as shown. Apply a small dab of glue to
each of the knots and allow the parachute to dry
before installing in the rocket.
… 57. Once the rocket is completely dry, tie the
shock cord to the nose cone and apply tape to
the remaining tail to prevent the knot from coming
loose.
… 58. To attach the parachute, collect the three
shroud lines from the parachute, pass them
through the loop on the nose cone, and pull the
parachute back through the ends, pulling the knot
tight.
Finishing:
Finishing a scale model can be a complicated process depending upon how exact the modeler wishes to be in
duplicating a particular prototype vehicle. The process described here is for a rough approximation of the standard
Black Brant VC paint scheme with black, silver, and gray over the majority of the rocket; it does not represent a
particular prototype. While the overall process would remain similar for specific prototypes, additional steps may be
required depending upon the complexity of masking required.
Step 55
Step 56
Tape Together to
Step 57
Prevent Untying
Step 58
2
1
3
Page 13