AUSSIE TONNEAU ATB01030 Handleiding voor installatie-instructies - Pagina 5
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} AUSSIE TONNEAU ATB01030. AUSSIE TONNEAU ATB01030 6 pagina's. Ford ranger px single cab with headboard
Pagina afdrukken
22. Partially peel the backing paper from the driver's side seal.
Align the notched section and the first hole to the vehicle
and apply the seal tape to cover the gap between the
headboard and the cabin end of the tub. Refer figure 14
23. Remove the rest of the backing paper and finish applying
the seal.
24. Repeat for Passenger side.
25. Use the remainder of the tape to cover the remaining gap between the center section of the
headboard and the cabin end of the tub. Overlap the remaining tape evenly at both ends (approx.
30-40mm). Refer figure 16
2. CARING FOR YOUR TONNEAU
Apply bee's wax or Dri-lube to the stitching a few times a year, as this will maintain the tonneau's
waterproofing ability and prevent the stitching from degrading. Use a mild detergent and soft scrubbing
brush to clean tonneau.
Never drive without tonneau support bars in place as the flapping can cause a delaminating effect on the
3. MULTI-FIT SUPPORT BAR
The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all Utes on the Market, from Suburu
Brumbys to Cab Chassis aluminium trays.
3.1 BASIC TOOL REQUIRED
Drill, 4mm drill bit
-
3.2 MULTI-FIT SUPPORT BAR CONTENTS
-
1 x hollow bar centrepiece
-
2 x solid bar end piece
"Tonneau is not designed to be used as a load restraint"
-
Figure 16
material.
2 x grub screws
Figure 15