ADE M600020 Bedieningshandleiding - Pagina 6

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} ADE M600020. ADE M600020 16 pagina's. Electronic bed scale

Pagina afdrukken

Housing and connections

The connections to mains adapter, serial port and to the load cells are located at the back of the ADE display.

The set-up switch to start the configuration mode is underneath the housing. It is protected by a cover plate

and secured by a screw (not shown in Fig. 2-1).

Do not use the set-up button, as otherwise calibration will be lost. This procedure is only al-

lowed by authorized service personnel appointed by ADE (GmbH & Co.). Any unauthorized ma-

nipulations made to the configuration mode will affect the warranty agreement.

The ADE-display unit (MAK) corresponds to the latest state of the art technology and complies with standard

regulations and directives. Kindly follow the safety instructions in this operating manual, the country-specific

installation standards as well as the applicable safety conditions and accident prevention regulations in all

aspects. Electronic medical devices are restricted to special safety regulations in respect of their electromag-

netic compatibility. For positioning and operation, follow the instructions of this operation manual.

–

Portable and mobile HF-communication systems may influence electronic medical devices.

–

Make sure that the mains cable does not pose any potential trip hazard.

–

Do not drop the weighing bridges/shoes or subject them to violent shocks.

–

Do not operate the unit in hazardous or unstable conditions.

–

Do not dip or submerge the unit into water or other liquids.

–

Have all repairs and calibration carried out by professional personnel authorised by ADE.

–

Set up the unit as far away as possible from equipment that generates electromagnetic or other interfer-

ence.

–

Only use original rechargeable batteries and mains adapter from ADE. The warranty does not cover any

damage caused by using other types of batteries or charger units.

Safe operation is no longer guaranteed:

If the power unit shows visible damage.

If the power unit is not working properly.

After longer periods of storage in damp areas.

In these cases, contact your service partner for your own safety!

The following functions are available in setting mode:

–

Configuration of the serial interface

–

Set up of date, time and consecutive printout numbers

–

Set up of print format

–

Set up of switching points

–

Test functions

Safety

Settings

M600020-210322-Rev008-UM-e