AUSTRAL CLOTHES HOISTS RetractAway 40 Handmatig - Pagina 4

Blader online of download pdf Handmatig voor {categorie_naam} AUSTRAL CLOTHES HOISTS RetractAway 40. AUSTRAL CLOTHES HOISTS RetractAway 40 5 pagina's.

Pagina afdrukken

1. Mix concrete in the ratio of 4 gravel, 2 sand and 1 cement or simply use premixed concrete packs. To hold the

Post/Socket erect, the concrete must be mixed fairly dry but should still be wet enough that it sticks to itself when

squeezed in the hand, it should not crumble.

2. Place the Post / Socket (with Post in it) in the hole. Ensure the Cabinet and/or Receiving Catch is facing the

right way. Pour concrete to within 20mm from the top of the hole (finished ground level). See Figure 5d. Check the

Post is plumb/vertical using a spirit level. Use a crowbar or similar to ram the concrete tight so it holds the

Post/Socket in place. If the concrete has dropped below 20mm, top up with more concrete, check vertical and ram

tight again. Fill last 20mm of hole with soil, press soil down gently with the sole of your shoe. Check vertical one

last time. Now leave the concrete to set. DO NOT USE FOR 48 HOURS.

LINE TENSIONING

If Posts have been installed ensure concrete is set and dry

before tensioning the lines. Extend the Draw Arm to the

Receiving Catch. Flick the Line Tension Lock to the locked

position at the Cabinet. Turn the Tension Knob a click or 2 in a

clockwise direction. See Figure 4. Starting on the middle line,

uncleat the cord then pull the loose end to take up the slack.

See Figure 6a. Recleat the cord and fit it back into the Cord

Tidy. See Figure 6b. Repeat for the 2 outside lines then the

remaining 2 lines. Tension one cord at a time and ensure it is

recleated and back in the Cord Tidy before starting another.

After all lines have been tensioned, snip off excess cord allowing

20mm tail. See Figure 6b.

RETRACTING THE CORD

Switch the Line Tension Lock to the unlocked position before

retracting the Cord back into the Cabinet, this ensures minimum

wear on internal gears. If there is a lot of tension on the Cord,

the Lock may be harder to move. To make it easier, take tension

off the Lock by turning the Tension Knob clockwise a little with

the right hand. Whilst doing this, switch the Lock to the unlocked

position with your the left hand. Then, unhook the Draw Arm

from the Catch and slowly guide the Cord and Draw Arm back

into the Cabinet.

MAINTENANCE & TIPS

Occasionally check all nuts and bolts for tightness.

Keep the Cap on the Ground Socket whenever the Post is removed.

Re-tension Cords occasionally as required.

WARRANTY

Please see separate page for Austral's Warranty.