AUSUM ML-CS37-36 Montage-, gebruiks- en onderhoudshandleiding - Pagina 8

Blader online of download pdf Montage-, gebruiks- en onderhoudshandleiding voor {categorie_naam} AUSUM ML-CS37-36. AUSUM ML-CS37-36 12 pagina's.

Pagina afdrukken

7、ASSEMBLY

Adjustable handle

This machine can be used as straight grip or pistol grip. Push adjust handle lock switch and hold to rotate the handle to the desired position. Release

the adjust handle lock switch, and then you can use the tool.

To charge the tool

The tool must be charged prior to the ﬁrst start-up.

1.Connect the USB cable to the charging socket.

2.Connect the other end of USB cable to the computer's USB port or a USB charger on a wall socket(sold separately or the other telephone adaptor which

output current less than 2.1A)

3a. If the USB cable connected on the tool, during charging, the LED display of the tool shows red light. When it shows green light, the charging is ready.

3b. If the USB cable connected on the base, the LED display of the base shows green and ﬂashing in order, When it shows all green light, the charging is ready.

4.This screwdriver has integrated over-charged protection, when the battery cell is over-charge protection will operate to stop charge battery.

5.The battery is fully charged after 3-5 hours charging.

6.During the charging procedure, the handle of the machine warms up, this is normal.

7.After charging is ﬁnished, disconnect the USB cable

NOTE:

If the tool is hot, allow it to cool to ambient temperature before charging. To prevent damage to the battery, charge the battery to at least a half-charge before

storing. If the tool will not be used for long periods of time, charge the tool every 3-6 months.

Change the bit

Inserting bits-Insert the screwdriver bit directly into the hexagon collects, it will be held automatically by the suction

Removing bits-Pull out ﬁrmly the screw driver bit

Note:

Do not use double-sided screwdriver bits that are longer than 25mm.

LED light

The screwdriver has a built-in LED light to illuminate the work area and improve vision when working in areas with insuﬃcient light. The LED light will be

automatically turns on while depressing the trigger switch.

8、USE

ON/OFF switch trigger

To start the tool, press the ON/OFF switch and keep it depressed. To switch oﬀ the tool, released the ON/OFF switch.

Forward/reverse switch

The forward/reverse switch is used to reverse the rotational direction of the tool.

Push the forward/reverse switch lever right to the stop(for screwing-in screws)

Push the rotational direction switch left to the stop(loosening or unscrewing screws).)

Torch's ON/OFF switch

There is a torch in the end of the machine.

OFF The torch produces a light beam that emerges from the lamp head.

To start the torch, push the switch to "on" position.

To turn oﬀ, push the switch to "oﬀ" position.