Airwell RC4 Handleiding voor programmering en bediening - Pagina 8

Blader online of download pdf Handleiding voor programmering en bediening voor {categorie_naam} Airwell RC4. Airwell RC4 14 pagina's.

AUTO COOLING / HEATING OPERATION

Select the AUTO mode by pressing MODE button (2). Switch to the desired

FAN SPEED or to AUTO FAN by pressing button (4). Select suitable

temperature setting. The air flap will automatically move to either horizontal

air delivery for cooling or to vertical air delivery for heating. At start, the air

conditioner will select its mode of operation according to the room

temperature and the temperature setting.

Select the DRY mode by pressing MODE button (2). Select the suitable

temperature setting. While in DRY mode, the air conditioner will operate at low

fan speed, regardless of the fan setting on the LCD operation display. Fan

might terminate operation from time to time to prevent from over cooling. By

selecting the mode, the air flap will move automatically to optimal horizontal

air delivery position.

Press TEMP buttons (5) or (6) to change the temperature setting in the LCD

operation display (13). The temperature setting is shown in degrees

centigrade. A higher number indicates a higher room temperature. A lower

number indicates a lower room temperature

Press I FEEL button (3) to activate the I FEEL function. Thermometer sign

will appear on the LCD operation display (13). Select suitable temperature

setting.

Make sure that the remote control unit is aimed at the air conditioner, with

the I FEEL sensor (14) in front. Prevent the I FEEL sensor from being

affected by heat sources such as lamps, heaters, direct sun, etc. or from

being directly affected by the air conditioner air flow. These may cause the

sensor to transmit the wrong temperature data, thereby disturbing the

performance of the I FEEL function.

Press SLEEP button (7) to select the SLEEP function.

The sleep icon light while the sleep OFF time icon and the time which is 7 hours

after current time blink as deafult. The default setting can be changed from 3 hr.

to 12 hr. by pressing up and down buttons HOUR+ (11) and HOUR- (12)

respectively.(The sleep timer will display the default time or the setting time plus

the current time initially in the display).

For example : currrent time is 23:00 and the sleep mode is set , the sleep mode

OFF time will be 6:00 . If the sleep off time is set to 10 hr, then the sleep mode

OFF time will be 9:00.All other timers will temporarily be suspended during the

activation of the sleep timer.

The other timers will resume operation at the end of the SLEEP time.

To cancel the SLEEP function press one of the following:

NOTE: In some models the SLEEP icon lights only and the OFF time is set for

seven hours as default.

START / STOP button (1)

SLEEP button (7)