Aircommand 5860001 Handleiding Handboek - Pagina 4

Blader online of download pdf Handleiding Handboek voor {categorie_naam} Aircommand 5860001. Aircommand 5860001 17 pagina's. Roof top air conditioner

1. Installation Position

Before beginning, mark out the position of the unit

considering the following important requirements:

• The air conditioner should be situated as centrally as

possible on the van, to ensure even air distribution.

• The Sparrow Mk4 may be oriented in any direction to the

normal direction of travel.

• When considering the installation position remember to

check for clearance around the plenum inside the van.

• Avoid an installation position where a bulkhead, cupboard

or light ﬁ tting could interfere with the discharge air ﬂ ow

from the plenum.

• Avoid an installation where a roof joining seam crosses

through the 14" square installation cut out.

It is important that the unit is never more than 5° from

the horizontal and the rear of the unit should never be

higher than the front when in use.

Contact Aircommand if your installation differs signiﬁ cantly.

• The above outline on the left shows the minimum

clearance required around the Sparrow Mk4 unit on the

roof of the vehicle, distances shown are calculated from a

14" square hole (356 x 356mm).

• The above outline on the right shows the minimum

clearance required around the 14" square hole (356 x

356mm) in order to accommodate the plenum.

Installation

There should be a minimum

of 100mm clearance around

the perimeter of the unit to

allow for service access and

air ﬂ ow to condenser.

Fig 1: Sparrow Mk4 clearances required around roof top unit.

14" x 14" (356mm)

Fig 2: The foot print of the rooftop unit, and the plenum,

measured from the hole.

Hot air is ejected from

this exhaust; consider

nearby roof hatch.

square hole