GREAT PLANES FW-190 Focke Wulf Gebruiksaanwijzing - Pagina 9

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} GREAT PLANES FW-190 Focke Wulf. GREAT PLANES FW-190 Focke Wulf 20 pagina's.

❏ ❏

3. Slide the loose carbon rod through the bearings.

❏ ❏

4. Test fit an aileron onto the carbon rod as shown. If

satisfied with the fit, glue the aileron to the carbon rod using

CA. DO NOT glue the aileron to the bearings. The rod must

freely rotate in the bearings, so the aileron must only be

glued to the carbon rod.

Install the Servos

❏

1. Remove the screws and servo arms from all of your

servos. Enlarge the hole in the center of the servo extender

until the head of the servo screw passes through.

❏

2. Trim the mounting posts off of the servo as shown in

the photo.

❏

3. Place the original servo arm over the screw, and glue the

top of the arm to the extender with CA. Some servo arms have

small flanges projecting from the top. If your servo arms have

these flanges, sand them off before gluing.

❏

4. Use epoxy to glue a servo into the bottom of the rear

servo cutout from the left side of the plane. The output shaft

should be toward the front of the fuselage. Center the servo

with your radio and screw the extended arm onto the output

shaft with the arm oriented straight up.