ADENDORFF MAC AFRIC SDRILC-024 Originele gebruiksaanwijzing - Pagina 7

Blader online of download pdf Originele gebruiksaanwijzing voor {categorie_naam} ADENDORFF MAC AFRIC SDRILC-024. ADENDORFF MAC AFRIC SDRILC-024 11 pagina's. Cordless brushless rotary hammer

Pagina afdrukken

Model

Input Voltage (AC)

Charging Current

Input Power Frequency

Applicable Battery Cartridge Voltage (DC)

4.0Ah

Full Charging Time

5.0Ah

6.6Ah

Insulation Grade

Switch Action

CAUTION:

Before inserting the battery cartridge into the tool, always check to see that the switch



trigger actuates properly and returns to the "OFF" position when released.

Do not operate the machine at a low



speed for too long, or the inside machine

may be overheated

To start the tool, simply pull switch trigger.

Tool speed is increased by increasing pressure

on the switch trigger and further pressure

results in an increase in speed. Release the

switch trigger to switch off the tool. (Fig. 5)

Reversing Switch Action

CAUTION:

Always check the direction of rotation before operation.



Use the reversing switch lever only after the tool comes to a complete stop. Changing

the direction of rotation before the tool stops may damage the tool. When not operating

the tool, always set the reversing switch lever to the neutral position

Never force to pull the switch trigger while the the reversing switch lever is set to the



center position.

FFCL18-01

SCHARG-001

FFCL18-05

FFCL18-03

(FFCL18-04)

220-240V

110-240V

220-240V

3.0A

2.0A

50-60Hz

18V

≈90min

≈135min

≈100min

≈150min

≈140min

≈210min

Double Insulation

Clockwise Rotation

Depress the reversing switch lever from side B

to side A for clockwise rotation. (view

forwards).

Counterclockwise Rotation

Depress the reversing switch lever from side A

to side B for counterclockwise rotation. (Fig 6)

When set the reversing switch lever to the

neutral position, the button is locked, and

cannot be pressed

Installing or Removing Drill Bit

Apply a small amount of bit grease on the drill bit shank head beforehand, about 0.5-1 g, to

ensure smooth action of the chuck and prolong its service life.

CAUTION:

 Before operation, always set the reversing

switch lever in the central position and

remove the battery. Mustn't press switch

trigger.

Clean the bit shank and apply bit grease

before installing the bit. Insert the bit into the

tool. Turn the bit and push it in until it

engages. (Fig. 7)

Demount the drill bit if it cannot be pushed

into. Pull down the locking sleeve several

times, and insert into the drill bit again. Turn

the bit and push it in until it engages.

Pull the drill bit to check that it is locked

correctly.

To remove the bit, push back the locking

sleeve and remove the bit (Fig. 8)