activTek INDUCT 10000 Handmatig - Pagina 12

Blader online of download pdf Handmatig voor {categorie_naam} activTek INDUCT 10000. activTek INDUCT 10000 16 pagina's. Electronic air purification system
Ook voor activTek INDUCT 10000: Handmatig (16 pagina's)

Pagina afdrukken

1. Replacement Parts

CHANGING THE BALLAST

WARNING: Disconnect power at the

Remove the two (2) thumb nuts on the

top and bottom side of the ballast to pull

ballast from assembly.

To reconnect wiring, insert wire into

the corresponding color connector.

Gently pull back after inserting wire

to ensure the wire is properly locked

into place.

UPPER (3 terminals)

• Black power wire in BLACK

• White power wire in WHITE

• GREEN is not used

LOWER (6 terminals)

• 2 Red wires in RED

• 2 Blue wires in BLUE

(INDUCT 10000 ONLY)

• 2 Yellow wires in YELLOW

breaker or fuse panel before

servicing unit.

Open the ballast housing by

removing the four (4) thumb

screws then remove the cover.

Remove the wires from ballast

by pressing a small screwdriver

into the wire release:

• INDUCT 10000 - 8 wires

• INDUCT 5000 - 6 wires

CAUTION: Never attempt to check

operation of the ActivePure®

cell(s) by direct observation.

Severe eye damage can result.

Use the indicator lamps on the

bottom of the ballast only.

CAUTION: Disconnect power at the

breaker or fuse panel before

servicing unit. Always follow

OSHA lockout procedures to

prevent accidental exposure

to electrical energy.