Autool BT460 Handmatig - Pagina 3
Blader online of download pdf Handmatig voor {categorie_naam} Autool BT460. Autool BT460 6 pagina's. Auto battery tester
Pagina afdrukken
Resistance
Life
Test result
Note:
(a) When battery voltage is lower than normal test voltage, the test result can not
judge the battery state. It will show "Re -test after charging". At this time, please
charge the battery, then test it.
(b) When battery voltage is too high or the vehicle is startin g, the test can't be
proceeded. It will show "The voltage is too high. Please turn off the engine! Please
turn on the headlights in 3 minutes, then test it."
(c) For deep loss battery (For expample, the vehicle is on hold for a long time; the battery is
not charged in time; the headlight or door is forgotten to turn off/close , which cause
battery loss deep, and vehicle can't start), it may show "Please replace the battery" during
test. For such batteries, please consult the battery manufacturer to restore charging , then
test it.
II. Cranking Test
After battery test, press UP/DOWN key to select cranking test. Then, press ENTER
key to cranking test:
Current
Minumum voltage
Minimum cranking voltage
9.6V is regarded as abnormal, which may be caused by battery aging which can't
provide sufficient cranking current, or because of starter worn or poor mechanical
lubrication.
In the state of engine off, it will show "Start engine, and wait for 15 seconds!"
Start engine, and wait for the test result.
III. Charging Test
18.5mΩ
------Battery resistance
95%
-----------Battery remaining life
Good ------------Battery state
12.5V
11.1V
9.6V
BT 460 车辆蓄电池检测仪使用说明书
----current voltage
--------Minimum voltage tested
--------Cranking voltage lower than