Galvamet MAGIC Handmatig - Pagina 3

Blader online of download pdf Handmatig voor {categorie_naam} Galvamet MAGIC. Galvamet MAGIC 14 pagina's.

INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS FOR COOKER HOOD

Exhausting cooker hood. The equipment is constructed in accordance with European Standards and with the requirements included in the following Directives:

2006/95EC ( Low Voltage Directive), 2004/108 (Electromagnetic Compatibility).

INSTALLATION

Read the instruction manual before installing and/or using the hood.

In order to respect the minimum distance of at least 65 cm, in accordance

with the present regulation, between the supporting surface for cooking

vessels on a gas hob and the low voltage components in the range hood, the

lowest part of the range hood must be at a distance of at least 50 cm from

the hob (Fig. 1).

If the mounting instructions of the gas cooker indicate a wider distance,

respect it.

The unit must not be mounted above cookers fitted with top radiant plate.

Respect all the air discharge regulations.

The air must not be discharged in a pipe used to discharge exhaust fumes

produced by gas-fed equipments or fuel-fed equipments (this does not apply

to filtering hoods).

The room must be adequately ventilated when the hoods is used together

with other gas-fed or fuel-fed equipments.

For an easy access, it is advisable to move possible furniture under the

installation area.

As to positioning and fixing the back of the unit, use the back securing device

supplied as shown in Fig. 7.

ELECTRICAL COMNNECTIONS

This equipment must be connected to a plant featuring a grounding.

Two types of electrical connection can be used:

•

Using a standard plug connected to the power cable and inserted in a

mains socket which must be accessible at all times (so that the plug

can be disconnected when servicing is carried out).

•

By means of a fixed mains connection, fitting a bipolar switch with

contact openings of at least 3 mm. The ground connection (yellow-

green wire) must not be interrupted.

Refer to the plate inside hood for the mains voltage and frequency ratings.

EMPLOYMENT

This cooker hood can be employed as exhausting or filtering.

Exhausting (external evacuation – Fig. 2). Activated charcoal filters are not

to be put in the exhausting version .

Kitchen smokes are discharged externally by means of a flue joined to the

discharge connector of the cooker hood. The flue should communicate with

the outside of the houseThis pipe must not under any circumstances be

connected to cooker, boiler or burner exhaust pipes, etc.

Filtering (inside recycling – Fig. 3). Waste gases and vapours when cooking

are filtered through active carbon filters, depurated and re-circulated into the

kitchen through a tube connected to the ducting fitting (spigot) on the

cookerhood, which conveys the air to a hole on the upper part of the wall

mounted unit. Always keep this hole free of obstacles to permit the air to

return into the kitchen.

OPERATION

The hood is supplied with a multispeed motor.

The hood should be run at low speed under normal conditions and at higher

speeds only when there is a heavy build-up of fumes or odours.

Ideally, the hood should be switched on as soon as cooking is started and

then kept on until all odours have been eliminated.

To switch on the light, press and release the knob, then turn it to start the

extractor and change speed. Press and close the knob at any speed setting

to switch off the light (Fig. 6).

MAINTENANCE

Always disconnect the hood from the mains before carrying out any

maintenance or cleaning operation.

In order to remove the remaining glue or any impurity, the cooker hood must

be cleaned immediately after installation and after having removed the

protective film.

The cooker hood must be cleaned frequently both internally and externally.

Do not let dirt gather on the inner and outer surfaces of the hood.

To clean the exterior of the hood do not use either acid or basic products, or

abrasive sponges.

Clean the hood with a sponge dampen in warm water and a little quantity of

neutral detergent (for example dishwasher detergent), in order to remove

possible particles of grease.

Rinse with a damp cloth, removing all the detergent carefully, following the

satin finish direction on the steel surface.

Drying is very important, especially in areas where water is particularly hard

and leaves limestone.

MOD. OPTIMA 230-240 Vac - 50 Hz

ANTI-GREASE METALLIC FILTERS need specific care, as a matter of fact

their function is to hold the grease particles contained in the fumes. The

metallic fat-retaining filter must be washed at least once a month with

detergent in hot water (or in the dish-washer).

When taking off the anti-grease metallic filters you should follow instructions

in (Fig. 4). We would advise to install once again the anti-grease metallic

filters only when they are perfectly dry.

ATTENTION: the grease collected in the filter can easily catch fire and it is

therefore extremely important to clean the metallic filter on a regular basis as

per instructions.

The ACTIVATED CARBON FILTER is designed to collect unpleasant odours

in the cooking fumes.

The purified air is then released into the room. The carbon filter must not be

washed, but both replaced 2 or 3 times a year, depending on how much the

hood is used. New filters can be obtained from our Customer Service Centres

or directly from the manufacturer.

To replace the activated charcoal filters, first remove the greaseproof metal

filters (Fig. 4) and then remove the activated carbon filters at the ends of the

extractor (Fig. 5A). Turn the filters clockwise until they detach from the

extractor. To remove the filters from the box, position them as indicated (Fig.

5B).

In order to install again the new activated charcoal filters, you should reverse

the operations.

To replace the LED lamp, contact the service centre nearest to you.

WARNINGS

The present instruction manual is an integral part of the appliance itself,

therefore it must be carefully kept and ALWAYS accompany it, even in case

of its assignment to another owner or user or in case the cooker hood is

moved to another installation plant.

Any eventual adjustment to the electrical system, which may be necessary to

install the cooker hood, must be carried out only by competent people. Any

repair carried out by no competent people may cause damages. For any

repair or needed technical action make reference to a Technical Assistance

Center, which is authorized to carry out the replacement of the spare parts.

Always make sure that all the electrical parts (lights, exhaustion unit) are

disconnected when the appliance is not in use.

By storms take off the main switch of the house electrical system.

The using of the cooker hood must not be other than the use of exhausting

units for cooking damps on domestic kitchens. The manufacturer does not

accept any liability for damages caused by people, animals or things, by

installation and maintenance mistakes or by any illegitimate use.

Make sure that the voltage (V) and the frequency (Hz) ratings indicated on

the plate inside the cooker hood correspond to the ones available in the

installation place.

We remind that the use of products functioning with electrical energy implies

the observance of some essential security rules, as follows:

• This equipment is not intended for people (children included) with reduced

mental or motor capacities, with lack of experience or knowledge, unless

they are supervised or unless a person responsible for their security, gives

them instructions regarding the use of the equipment. Children must be

supervised in order to be sure that they do not play with the equipment.

• Any cleaning action is forbidden if the appliance hasn't been disconnected

from the main power supply and if the main switch of the house electrical

system is not off. If cleaning is not carried out according to these instructions,

a fire may break out.

• Do not pull, take off or twist the cable coming out from the appliance, even

though this has been disconnected from the main power supply.

• Do not sprinkle or throw any water directly on the appliance.

• Do not stick any sharp tool inside the exhausting holes and into the air

discharge.

• Do not take out the filters in order to reach the internal sides of the

appliance in case the main switch of the house electrical system is not off.

• Do not singe or flambé directly underneath the cooker hood. Take particular

care when frying to ensure that the oil does not catch fire.

In the to www.galvamet.it site, it is possible to check the list of our

authorized service centres and download the conventional warranty

certificate.