IKEA ENASTAENDE Gebruikershandleiding - Pagina 15
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} IKEA ENASTAENDE. IKEA ENASTAENDE 24 pagina's. Enastående
Pagina afdrukken
ENGLISH
Problem
The programme does
not start.
The appliance does
not fill with water.
The appliance does
not drain the water.
The salt indicator con-
tinues to stay on after
the replenishment of
the salt container.
After the checks are completed, activate the
appliance. The programme continues from
the point of interruption.
If the problem occurs again, contact the
service.
If the display shows other alarm codes, con-
tact the service.
Possible cause
The mains plug is not connec-
ted in the mains socket.
The appliance door is open.
The fuse in the fuse box is
damaged.
The delay start is set.
The water tap is closed.
The water pressure is too low.
The water tap is clogged or
there is limescale on it.
The filter in the water inlet hose
is clogged.
The water inlet hose has a kink
or a bend.
The anti-flood device is on.
There are water leakages in
the appliance.
The sink spigot is clogged.
The water drain hose has a
kink or a bend.
This can occur when you are
using salt that needs more time
to dissolve.
There is no unwanted effect on
the performance of the appli-
ance.
Possible solution
Connect the mains plug.
Close the appliance door.
Replace the fuse.
Cancel the delay start or wait
for the end of the countdown.
Open the water tap.
Contact your local water au-
thority.
Clean the water tap.
Clean the filter.
Make sure that the position of
the hose is correct.
Close the water tap and con-
tact the service.
Clean the sink spigot.
Make sure that the position of
the hose is correct.
If after 3 or 4 programmes, the
salt indicator continues to stay
on, contact the service.
If the washing and drying results are not
satisfactory
Whitish streaks or bluish layers on glasses
and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
• The quantity of detergent is too much.
15