Alirac HE115-125/950 Gebruikershandleiding - Pagina 4
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Alirac HE115-125/950. Alirac HE115-125/950 10 pagina's.
Pagina afdrukkenthe flange (especially the installing surface)
or the lock nut. Damage to these parts could
result in wheel breakage.
9.NEVER use tool with wood cutting
blades or other saw blades. Such blades when
used on a grinder frequently kick and cause
loss of control leading to personal injury.
10.Hold the tool firmly.
11.Keep hands away from rotating parts.
12.Make sure cord is clean . Do not
wrap cord around your arm or wrist. If tool
is out of control, cord may become wrapped
around you and cause personal injury.
13.Make sure the wheel is not contacting
the workpiece before the switch is turned on.
14.Before using the tool on an actual
workpiece, let it run for a while. Watch for
vibration or wobbling that could indicate
poor installation or a poorly balanced wheel.
SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety rules stated in this instruction manual may
cause serious personal injury.
SYMBOLS
The following show the symbols used for the tool.
V-----voltage
A-----ampere
Hz---hertz
Fig1
15.Use the specified surface of the wheel
to perform the grinding.
16.Watch out for flying spark. Hold the
tool to let the spark fly away from you and
other persons for flammable materials.
17.Do not leave the tool running.
Operate the tool only when hand-held.
18.Do
immediately after operation; it may be
extremely hot and can burn your skin.
19.Always
including long sleeve shirts. Leather gloves
and shop aprons to protect skin from contact
with not grinding.
20.Use of this tool to grind or cut some
products. Paints and wood could expose user
to dust containing hazardous substance. Use
appropriate respiratory protection.
n-------no load speed
--/min -----revolutions or reciprocation per minute
Operation instructions:
Installing or removing grinding wheel.
To install the wheel guard and retaining
plate on the front cover, then align the three
holes of retaining plate with front cover
screw holes, finally use the three screws to
tighten it.
Installing or removing grinding wheel
Caution:
When using an abrasive cut-off wheel,
be sure to use only the supplied wheel guard,
-3-
www.makute.com
not
touch
the
wear
proper
workpiece
apparel