Brother P-touch H500 Handleiding voor snelle installatie - Pagina 10

Blader online of download pdf Handleiding voor snelle installatie voor {categorie_naam} Brother P-touch H500. Brother P-touch H500 36 pagina's.

Brother P-touch H500 Handleiding voor snelle installatie
INTRODUCTION
Alkaline batteries/Ni-MH rechargeable batteries
Follow these guidelines to avoid liquid leakage, overheating or rupture of the battery.
DO NOT use a battery other than the
one specified for use with your
P-touch. Do not use combinations of
old and new batteries or combinations
of different types, different charging
levels, different manufacturers or
different models. Do not insert a
battery with the polarity (+ and -)
reversed.
If fluid leaked from the battery gets on
your skin or clothes, immediately rinse
them with clean water.
Remove the batteries if you do not
intend to use the P-touch for an
extended period of time.
AC Adapter (AC Adapter optional with the H500)
If you do not intend using the P-touch
for an extended period of time,
disconnect the AC adapter from the
power outlet.
When disconnecting the AC adapter
from the power outlet, always hold the
AC adapter.
DO NOT use the AC adapter in places
of high humidity such as bathrooms.
Tape Cutter
Follow these guidelines to avoid minor personal injury and damage to the P-touch.
DO NOT open the tape compartment
cover when operating the cutter unit.
10
Safety Precautions
CAUTION
Before using Ni-MH rechargeable
batteries, carefully read the
instructions for the batteries and
battery charger, and be sure to use
them correctly.
When using Ni-MH rechargeable
batteries, charge the batteries with the
appropriate, specialized battery
charger.
DO NOT disassemble or modify the
batteries.
DO NOT expose the batteries to heat
or dispose of the batteries in a fire.
DO NOT overloading electrical circuit
the power cord.
DO NOT disassemble or modify the
AC adapter.
DO NOT allow the AC adapter/power
plug to get wet, for example, by
handling them with wet hands or
spilling beverages on to them.
DO NOT apply excessive pressure to
the cutter unit.