Indesit WE 8 X Handmatig - Pagina 10

Blader online of download pdf Handmatig voor {categorie_naam} Indesit WE 8 X. Indesit WE 8 X 17 pagina's.

Pagina afdrukken

The washing machine

does not drain or spin.

Does

the

selected

programme incorporates

water draining? Some

programmes stop at the end

of the wash cycles and

draining will have to be

selected manually.

the

"Rinse

function -where provided -

selected? Complete the

programme by pressing the

select button.

Is the drain hose kinked?

The tract of the drain hose

must be as straight as

possible. Make sure the drain

hose is not squashed or

kinked.

Always get

assistance from

authorised

technicians and

always insist on

original spare parts.

Technical characteristics

Model

WE 8 X

Dimensions

width 59,5 cm

height 85 cm

depth 53,5 cm

Capacity

from 1 to 5,5 kg

Electrical

voltage 220/230 Volt 50-60 Hz

connections

maximum absorbed power 1850 W

Water connections

maximum pressure 1 MPa (10 bar)

minimum pressure 0,05 MPa (0,5 bar)

drum capacity 46 litre

Spinning speed

up to 800 rpm

Control programs in

programme 2; temperature 60°C.

compliance with

carried out with 5 kg load.

IEC regulation 456

This appliance conforms with the following E.E.C. directives:

- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent modifications

- 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications

Is the washing machine's

drain duct clogged? Is there

an extension of the drain

hose? If so, is it positioned

incorrectly, blocking the

water flow?

Excessive vibration

during the spin cycle.

Have all transit screws been

Hold"

removed durind instal-

lation? See the following

page

procedures.

Has the washing machine

been levelled correctly? The

levelling of the appliance

should

periodically. Adjust the feet

and check them with a level.

Is there space between the

machine and adjacent

units? If it is not a built-in

model, the washing machine

will oscillate a bit during the

spin cycle. A few cm of space

should therefore be left

around it.

The washing machine

leaks.

Is the metal ring of the inlet

installation

hose properly attached?

Turn off the water supply,

unplug the appliance and try

tightening its attachment

without forcing it.

checked

Is the detergent dispenser

obstructed? Remove and

wash it under tap water.

Is the drain hose well

attached? Turn off the water

supply, unplug the appliance

and

try

attachment.

Too much foam.

Is the detergent appropriate

for machine washing?

Check whether the definition

on its label reads "for machine

wash" or "hand and machine

wash", or any other similar

wording.

Is the correct amount being

used? An excessive amount

detergent,

producing too much foam,

does not guarantee a more

effective wash, and causes

scaling in the internal parts of

the appliance.

If, despite all checks, the

washing machine fails to

function and the problem

persists, call your nearest

authorised Customer Service

Centre, providing the following

tightening

its

information:

- the nature of malfunction

- the model type no. (Mod. ....)

- the serial number (S/N ....)

This information can be found on

the data plate situated at the

back of the washing machine.

besides