Indesit IDL 505 Installatie- en gebruikshandleiding - Pagina 12

Blader online of download pdf Installatie- en gebruikshandleiding voor {categorie_naam} Indesit IDL 505. Indesit IDL 505 17 pagina's. Indesit dishwasher installation and use
Ook voor Indesit IDL 505: Installatie- en gebruikshandleiding (17 pagina's)

Pagina afdrukken

Installation

Positioning the Appliance

Position the appliance in the desired location. The back

should rest against the wall behind it, and the sides, along

the adjacent cabinets or wall. The dishwasher is equipped

with water supply and drain hoses that can be positioned

to the right or the left to facilitate proper installation.

Levelling the Appliance

Once the appliance is positioned, adjust the feet (screwing

them in or out) to adjust the height of the dishwasher,

making it level. In any case, the appliance should not be

inclined more than 2°.

If the appliance is level, it will help ensure proper perfor-

mance.

This dishwasher model can be built under a single worktop

(please read the relevant instruction sheet).

Cold Water Connection

This electric household appliance should be connected to

the water mains using the cold water supply hose provided

with the appliance only. Do not

use a different hose. In the

event of replacements, use

original spare parts only.

Connect the cold water supply

hose to a threaded 3/4 (gas)

connector, inserting the small

filter supplied with the

dishwasher and making sure

that it is fastened tightly in place

(see figure 2).

If the water pipes are new or

have not been used for an extended period of time, let the

water run to make sure that the water is clear and free of

impurities. If this precaution is not taken, there is a risk that

the water inlet can get blocked and damage the appliance.

Hot Water Connection

The water supply to the appliance can also be connected to

the house's hot water line (centralised system, heating

system), as long as it does not exceed a temperature of 60°

In this case, the wash cycle time will be shortened by about

15 minutes and the wash efficiency slightly reduced.

The connection must be made to the hot water line following

the same procedures as those for the connection to the cold

water line.

Drain Hose Connection

Fit the drain pipe into a drain

line with a minimum diameter

of 4 cm or place it over the

sink. Avoid restricting or

bending it. Use the special

plastic elbow provided (see fi-

gure) to position it in the best

possible way. The part of the

pipe marked with the letter A

should be between 40 and

100 cm above the ground.

The pipe should not be immersed in water.

Attention: The special plastic hose support must be solidly

fastened to the wall to prevent the drain hose from moving

and allowing water to spill outside the drain.

Electrical Connection

After making sure that the voltage and frequency values

for the current in the home correspond to those on the

rating plate (located on the stainless steel inner door of the

appliance) and that the electrical system is sized for the

maximum voltage on the rating plate, insert the plug into

an electrical socket which is earthed properly (the earthing

of the appliance is a safety requirement mandated by law).

If the electrical socket to which the appliance must be

connected is not appropriate for the plug, replace the plug,

rather than using adpators or the like as they could cause

overheating and burns.

Should the electricity supply cable be damaged, we

recommend that you only contact authorised Technical

Service Centres for the replacement.