AEG A72700GNW0 Gebruikershandleiding - Pagina 13

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AEG A72700GNW0. AEG A72700GNW0 24 pagina's.

Pagina afdrukken
AEG A72700GNW0 Gebruikershandleiding
Make sure the door is open and then:
1.
Loosen the upper edge of the grille by
pulling outward/downward.
2.
Pull the grille straight out to completely
remove it.
3.
Vacuum clean under the cabinet.

Defrosting of the freezer

The freezer compartment of this model, on the other hand, is a "no frost" type. This means
that there is no buildup of frost when it is in operation, neither on the internal walls nor on
the foods.
The absence of frost is due to the continuous circulation of cold air inside the compart-
ment, driven by an automatically controlled fan.
Periods of non-operation
When the appliance is not in use for long periods, take the following precautions:
1.
disconnect the appliance from electricity supply
2.
remove all food
3.
clean the appliance and all accessories
4.
leave the door/doors open to prevent unpleasant smells.
If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food
inside from spoiling in case of a power failure.

WHAT TO DO IF...

During operation of the appliance some smaller but annoying trouble can often occur,
which does not require calling a technician out. In the following chart information is given
about them to avoid unnecessary charges on service.
The operation of the appliance goes with certain sounds (compressor and circulating
sound). This not means a trouble, but a normal operation.
The appliance operates discontinuously, so the stopping of compressor does not mean be-
ing no current. That is why you must not touch the electrical parts of the appliance before
breaking the circuit.
Problem
The appliance is noisy.
The buzzer sounds. The
Alarm icon flashing.
Possible cause
The appliance is not supported
properly.
The temperature in the freezer is
too high.
What to do if...
Solution
Check if the appliance stands sta-
ble (all feet and wheels should be
on the floor). Refer to "Levelling".
Refer to "HighTemperature
Alarm".
13