AEG RCB531E1LW Gebruikershandleiding - Pagina 17
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AEG RCB531E1LW. AEG RCB531E1LW 24 pagina's.
Pagina afdrukken
Problem
There is too much frost and
ice on food products in the
refrigerator.
Water flows on the rear plate
of the refrigerator.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Water flows inside the refrig‐
erator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli‐
ance is too low/too high.
Possible cause
Temperature set in the appli‐
ance is too low and the am‐
bient temperature is too
high.
Food products are placed
too close to the temperature
sensor.
During the automatic de‐
frosting process, frost melts
on the rear plate.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
Food products prevent the
water from flowing into the
water collector.
The water outlet is clogged.
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The "FROSTMATIC func‐
tion" is switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
ENGLISH
Solution
Set a higher temperature.
Refer to "Control Panel"
chapter.
Keep a distance between
food products and the tem‐
perature sensor (a rectangu‐
lar indent in the right wall of
the refrigerator between the
glass shelves).
This is correct.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Make sure that food prod‐
ucts do not touch the rear
plate.
Clean the water outlet.
Attach the melting water out‐
let to the evaporative tray.
Switch off "FROSTMATIC
function" manually, or wait
until the function deactivates
automatically to set the tem‐
perature. Refer to "FROST‐
MATIC function" section.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
17