A.M.Leonard AM50P Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} A.M.Leonard AM50P. A.M.Leonard AM50P 8 pagina's.

Feed control knob/wire through the

T-handle until spring touches the round

hole. CAUTION: Do Not Compress Spring

At This Time. Feed wire through the

square handle tube. Be sure wire passes

above the bolts in the handle brace.

Secure T-handle to the tube with (1) 1/4-20

x 2" hex bolt. (2) washers, and (1) hex nut

in the bottom hole, and (1) 1/4-20 x 2 1/4"

hex bolt, (2) washers, and (1) hex nut in

the top hole as shown. Remove caution

label and push the thumb release toward

the center and push down knob and shutoff

spring until knob latches.

Wire Clip

Install gear cover assembly over gears and secure

with (2) #6-32 screws. Slide handle grips onto handle.

Soapy water will ease installation. (Do not use

petroleum based products.) The AM 50P spreader

should now be completely assembled and ready for

use.

ASSEMBLY, CONTINUED

Wire

Shutoff Plate

Remove Caution

Label

Thumb

Release

1/4-20 x 2 1/4"

Bolt & Washer

CAUTION: ONCE KNOB IS LATCHED,

DO NOT MOVE THUMB RELEASE UNTIL

YOU HAVE COMPLETED STEP #5.

Slide wire retaining clip onto wire as shown.

Insert wire through hole shutoff plate. Slide wire

retaining clip over shutoff plate and wire until the

clip locks into place.

Handle Grip

#6-32 Screw

Control Knob &

Wire Assembly

Spring

1/4-20 Hex

Nut & Washer

Handle Grip

#6-32 Screw