AVS RM Series Installatiehandleiding - Pagina 3

Blader online of download pdf Installatiehandleiding voor {categorie_naam} AVS RM Series. AVS RM Series 4 pagina's.
Ook voor AVS RM Series: Installatiehandleiding (5 pagina's)

AVS RM Series Installatiehandleiding
AVS RM70M
WIRE COLOUR
FUNCTION
RED (ACC)
+12v ACC supply
BLACK
Earth
GREEN
Switches display to V2
FEMALE RCA
V2 camera input
MALE RCA
V1 camera input
BUTTON
FUNCTION
POWER
Power on/off
+ or Ù
Adjust up
MENU
MENU – push to enter menu and scroll through functions
Includes: brightness, contrast, saturation, language, mode (16:9 or 4:3), image rotation, factory reset
- or Ú
Adjust display brightness/contrast down
V1/V2
Manually switch between camera inputs
AVS RM70C
WIRE COLOUR
FUNCTION
RED
+12/24v ACC supply
BLACK
Earth
GREEN
Switches display to C2
AV2 4 pin
V2 camera input & power
connector
12v out
AV1 4 pin
V1 camera input & power
connector
12v out
BUTTON
FUNCTION
POWER
Power on/off
V1/V2
Manually switch between camera inputs
MODE
Switch between standard/soft/vivid/light viewing options
-
Adjust display brightness/contrast down
MENU
MENU – push to enter menu and scroll through functions
+
Adjust display brightness/contrast up
AVS RM70
CONNECT TO
Appropriately fused +12v switched ACC supply
Good earth source e.g. vehicle body/chassis
Reverse signal/vehicle reverse light wire (+12v). Use red wire on AVS Camera's RCA lead
Reverse camera output. Monitor will power on when green wire is triggered 12v + / or
when monitor is manually turned on and V2 is selected
Camera output. Monitor will display V1 when manually turned on and V1 is selected /
will be over ridden by V2 if triggered.
CONNECT TO
Appropriately fused +12/24v switched ignition on supply
Good earth source e.g. vehicle body/chassis
Reverse signal/vehicle reverse light wire (+12/24v)
4 pin camera cable. Monitor will switch to display this input when a signal is
detected on green wire e.g. when the car goes into reverse. Display will switch back
to V1 or turn off if there is no signal on V2.
4 pin camera cable. Monitor will display C1 until a signal is detected on green wire.