Dell PowerVault 201S Handleiding vervangende instructies - Pagina 12
Blader online of download pdf Handleiding vervangende instructies voor {categorie_naam} Dell PowerVault 201S. Dell PowerVault 201S 14 pagina's. Dell powervault 20xs storage systems enclosure services
expander module installation
Ook voor Dell PowerVault 201S: Handleiding voor rekinstallatie (26 pagina's), Handmatig (9 pagina's), Update (4 pagina's), Configuratie (2 pagina's), Installatiehandleiding (48 pagina's)
Pagina afdrukken
12
Dell PowerVault 2xxS Storage Systems SCSI Backplane Board Replacement Instructions
1. Carefully insert the replacement enclosure services module into the mod-
ule bay. Push the module all the way to the back of the bay until it is seated
in the connector.
2. Using a Phillips-head screwdriver, tighten the captive screw at the top of
the enclosure services module to secure the module to the chassis.
3. Repeat steps 1 and 2 to install the remaining enclosure services module.
Install the Cooling Fans
NOTICE: In a nonredundant system, install the cooling-fan blank in
the same cooling-fan bay from which it was removed.
NOTE: In a redundant storage system, there are three cooling fans. In a nonre-
dundant storage system there are two cooling fans and one cooling-fan blank.
Because a cooling fan and a cooling-fan blank are installed in the same manner,
both components are referred to as a cooling fan in this procedure.
To install the cooling fans, perform the following steps:
1. Carefully slide the cooling fan into the empty cooling-fan bay. Push the
cooling fan all the way to the back of the bay until it is seated in the
connector.
2. Using a Phillips-head screwdriver, turn the two captive screws clockwise
until the cooling fan is secured to the cooling-fan bay.
3. Repeat steps 1 and 2 to install the remaining cooling fans.
Install the Power Supplies
NOTICE: In a nonredundant system, install the power supply and the
power-supply blank in the same power-supply bays from which they
were removed.
NOTE: In a redundant storage system, there are two power supplies. In a non-
redundant storage system there is one power supply and one power-supply
blank. Because a power supply and a power-supply blank are installed in the
same manner, both components are referred to as a power supply in this
procedure.
To install the power supplies, perform the following steps:
1. Carefully slide the power supply into the empty power-supply bay. Push the
power supply all the way to the back of the bay until it is seated in the
connector.
2. Using a Phillips-head screwdriver, turn the two captive screws clockwise
until the new power supply is secured to the power-supply bay.
3. Repeat steps 1 and 2 to install the remaining power supply.