Dell N1108T-ON Aan de slag handleiding - Pagina 22

Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Dell N1108T-ON. Dell N1108T-ON 27 pagina's.

with normal operation using the default system

configuration. Note: You can exit the setup wizard at

any point by entering [ctrl+z].

Would you like to run the setup wizard (you must

answer this question within 60 seconds)? [Y/N] y

Step 1:

The system is not set up for SNMP management by

default. To manage the switch using SNMP (required for

Dell Network Manager) you can

Set up the initial SNMP version 2 account now.

Return later and set up other SNMP accounts. (For

more information on setting up an SNMP version 1 or

3 account, see the user documentation).

Would you like to set up the SNMP management interface

now? [Y/N] y

To set up the SNMP management account you must specify

the management system IP address and the "community

string" or password that the particular management

system uses to access the switch. The wizard

automatically assigns the highest access level

[Privilege Level 15] to this account. You can use Dell

Network Manager or other management interfaces to

change this setting, and to add additional management

system information later. For more information on

adding management systems, see the user documentation.

To add a management station:

Please enter the SNMP community string to be used.

[public]: public

NOTE:

If it is configured, the default access level is set to the highest available

access for the SNMP management interface. Initially only SNMPv2 will be

activated. SNMPv3 is disabled until you return to configure security access for

SNMPv3 (e.g. engine ID, view, etc.).

Please enter the IP address of the Management System

(A.B.C.D) or wildcard (0.0.0.0) to manage from any

Management Station. [0.0.0.0]: 10.1.2.100

Getting Started Guide