Dell PowerEdge M420 Gebruikershandleiding - Pagina 20

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dell PowerEdge M420. Dell PowerEdge M420 26 pagina's. Dell poweredge blade servers getting started guide
Ook voor Dell PowerEdge M420: Informatie-update (38 pagina's), Release-opmerkingen (27 pagina's), Handmatig (25 pagina's), Gebruikershandleiding (23 pagina's), Belangrijke informatie Handleiding (35 pagina's), Handleiding bijwerken (32 pagina's), Handleiding bijwerken (28 pagina's), Gebruikershandleiding (22 pagina's), Aan de slag handleiding (12 pagina's), Handmatig (38 pagina's), Technisch handboek (46 pagina's), Technisch handboek (48 pagina's), Portfolio Handleiding (27 pagina's), Aan de slag handleiding (14 pagina's), Aan de slag handleiding (12 pagina's)

Rev 1.00

After loading the .pfw file, both the software and firmware will be programmed onto the

10GbE PTM.

Note The update process takes a few minutes.

At the end of this process, the following message will be displayed at the prompt:

# Received update image successfully. Changes will take effect after

next reboot.

Step 6. Exit the 10GbE PTM CLI to the CMC command line. Run:

# exit

Step 7. Power cycle the 10GbE PTM for the firmware to take effect. From the CMC command

line type the following command:

$ racadm chassisaction -m switch-<n> powercycle

Step 8. Wait for 20 seconds, and then connect to the 10GbE PTM. Run:

$ connect switch-<n>

You will be able to view the progress of the SW update.

Step 9. At the end of a successful SW update process, the following message will be displayed:

FW updated successfully!

Welcome to the Dell 10GbE PTM Management Console firmware X.X.XXX-<date stamp>

Figure 13: Transferring the .pfw File

Software User's Manual