Dell S3100 Series Aan de slag handleiding - Pagina 18

Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Dell S3100 Series. Dell S3100 Series 27 pagina's.
Ook voor Dell S3100 Series: Aan de slag handleiding (46 pagina's), Installatiehandleiding (45 pagina's)

Dell S3100 Series Aan de slag handleiding
NOTE: You must have a password configured on a virtual terminal line
before you can Telnet into the system. Therefore, use a console
connection when connecting to the system for the first time. Before
starting this procedure, be sure that you have a terminal emulation
program already installed on your PC.
NOTE: If you are configuring a stack of switches, serial console access
to the stack manager is available from any serial port using the local CLI.
Only one serial console session at a time is supported.
1.
Install an RJ-45 copper cable into the console port. Use a rollover cable
to connect the console port to a terminal server.
2.
Connect the other end of the cable to the DTE terminal server.
3.
Set the default terminal settings as follows.
9600 baud rate.
No parity.
Eight data bits.
One stop bit.
No flow control.
Accessing the RJ-45 Console Port with a
DB-9 Adapter
If the DTE has a DB-9 interface, you can connect to the console using an
RJ-45 to DB-9 adapter along with the RJ-45 rollover cable.
Table 1. Pin Assignments Between the Console and a DTE Terminal Server
Console Port RJ-45 to
RJ-45
Rollover
Cable
Signal
RJ-45 Pinout RJ–45 Pinout DB-9 Pin
RTS
1
NC
2
TxD
3
GND
4
GND
5
18
RJ-45 to
RJ-45 to
RJ-45
DB-9 Adapter
Rollover
Cable
8
8
7
6
6
2
5
5
4
5
Terminal
Server Device
Signal
CTS
DSR
RxD
GND
GND
Installing the Software