HP -380467-003 - COMPAQ PRESARIO C300 C500 C700 F500 F700 LAPTOP CHARGER Handmatig - Pagina 21

Blader online of download pdf Handmatig voor {categorie_naam} HP -380467-003 - COMPAQ PRESARIO C300 C500 C700 F500 F700 LAPTOP CHARGER. HP -380467-003 - COMPAQ PRESARIO C300 C500 C700 F500 F700 LAPTOP CHARGER 24 pagina's. Intervideo ã¥â®â¶ã¥âºâã¥â½â±ã©â„¢â¢ ã¥â¿â«ã©â‚¬å¸ã¥â€¦â¥ã©â€”â¨ã¦å’â€¡ã¥ââ€”
Ook voor HP -380467-003 - COMPAQ PRESARIO C300 C500 C700 F500 F700 LAPTOP CHARGER: Gebruikershandleiding (37 pagina's), Ondersteuningshandleiding (27 pagina's), Handmatig (10 pagina's), Snelstarthandleiding (8 pagina's), Aan de slag handleiding (2 pagina's), Belangrijke informatie (1 pagina's), Belangrijke informatie (1 pagina's), Belangrijke kennisgeving (1 pagina's), Aanvullende handleiding (1 pagina's), Ondersteuningshandleiding (29 pagina's), Handmatig (8 pagina's)

3 The memory module can be installed in only one

way. Match the notch on the module with the tab

on the memory socket. Push the module carefully

and firmly into the slot, ensuring that the latches on

both ends snap into place.

4 Replace any cabling that was removed.

5 Complete the procedures to replace the side panel

and close the PC. See "Opening and Closing the

PC" page 1.

Removing or Installing an

Add-in Card

An add-in card is a circuit board, such as a PCI or an

AGP card that fits into a PC add-in card slot. Your PC

contains several add-in card slots that can be used to

add components to your PC. The PC component

configurations vary by model.

WARNING: Do not overload the system by

installing add-in cards that draw excessive

current. The system is designed to provide

2 amps (average) of +5 V power for each

board/card in the PC. The total +5 V

current draw in a fully loaded system (one

with all add-in card slots filled) must not

exceed the total number of slots multiplied

by 2 amps.

A Phillips screwdriver is needed to remove, replace,

or add an add-in card.

1 Complete the procedures to prepare the PC and

remove the side panel. See "Opening and Closing

the PC" on page 1.

2 Gently lay the PC on its side.

3 Inside the PC, locate the add-in card slots on the

motherboard.

4 If you are replacing a card, make a note of any

external or internal cables attached to the card,

and then disconnect them.

5 Remove the add-in card slot cover by removing

the screw and then removing the cover from the

chassis.

Loosen the screw on the card you are replacing.

Hold the card at the top and carefully pull the card

straight out of the add-in card slot.

Upgrading and Servicing Guide