Allo RemoteControl WHY EVO Instructies

Blader online of download pdf Instructies voor {categorie_naam} Allo RemoteControl WHY EVO. Allo RemoteControl WHY EVO 2 pagina's.

FIXED CODE DUPLICATING PROCEDURES:

1. While pressing the button 1 of the "WHY EVO", at the same time press 4 times

the 2 button.

2. Release both buttons. Now the WHY EVO WHITE LED emits a short flash every 2

seconds.

3. Place the original remote control to be programmed in front of the "WHY EVO", at

about 5 cm of distance (as shown in the picture).

4. Press and retain pressed the button of the original remote control and wait for a

change flash (as a faster flash) of WHY EVO WHITE LED and a change of its color

(BLUE) that confirms the correct learning of code. This step may take a few

seconds and during that the color LED is WHITE.

5. While the BLUE LED is flashing, press the button of the "WHY EVO" where you

want to program the code just learnt, and retain pressed until the LED switches

off and an extended sound "BEEP" for a reconfirmation of the correct code

learning. This step may take some seconds.

6. The copy has been happened with success. Now check on the automation the

correct functioning of the new WHY EVO remote control.

Notes:

• If the WHITE LED flashes only 3 times (of WHITE color) and switches off, the code

has not learnt correctly. Please repeat the operation from the step 1.

• The WHY EVO memory is completely re-writable.

• To duplicate further buttons of WHY EVO, please repeat the operation from the step

Visit our Website: www.alloremotecontrol.com

WHY EVO

INSTRUCTIONS