Miller XT60 Handmatig - Pagina 26

Blader online of download pdf Handmatig voor {categorie_naam} Miller XT60. Miller XT60 40 pagina's.

5-2. Sequence Of Cutting Operation

Connect work clamp to a clean, paint-free

location on workpiece, as close to cutting

area as possible.

The pilot arc starts immediately

when trigger is pressed.

Raise trigger lock and press

trigger. Pilot arc starts.

Adjust torch speed so

sparks go thru metal and

out bottom of cut.

OM-254 449 Page 22

For standard (shielded) cutting, place drag shield on edge

of metal. For extended (non-shielded) cutting, use 1/8 in.

(3.2 mm) standoff distance (dragging tip will reduce tip life).

After cutting arc starts, slowly

start moving torch across metal.

Pause briefly at end of

cut before releasing trigger.



Postflow continues for approx. 20 seconds

after releasing trigger; cutting arc can be

instantly restarted during postflow by raising

trigger lock and pressing trigger.

Ref. 254 087-A