aquatherm 50341 Bedienings- en onderhoudshandleiding - Pagina 2

Blader online of download pdf Bedienings- en onderhoudshandleiding voor {categorie_naam} aquatherm 50341. aquatherm 50341 8 pagina's. Fusion for aquatherm green pipe, aquatherm blue pipe, aquatherm lilac pipe, aquatherm red pipe and aquatherm ti pipesystems from 16 up to 125 mm

Pagina afdrukken

PART A: hEATINg UP PhAsE / hANDLINg

Temperature pilot lamp

(yellow)

glows constantly while the

heat-up phase and blinks, when the

welding temperature is achieved

Operating lamp

(green)

glows constantly, as soon as

the device is conntected with

the power supply system

Part A: heating up phase

7. During the heating up phase tighten the welding tools carefully with

the Allan key.

Take care that the tools completely contact the heating plate. Never

use pliers or any other unsuitable tools, as this will damage the coating

of the welding tools.

8. The temperature of 260° C is required for the welding of aquatherm

PP-R pipes.

Acc. to DVS - Welding Guidelines the temperature of the welding

device has to be checked at its tool before starting the welding process.

This can be done with a fast indicating surface thermometer.

ATTENTION:

First welding - soonest 5 minutes after reaching of the welding

temperature. DVS 2207, Part 11.

Part A: handling

9. A tool change on a heated device requires another check of the welding

temperature at the new tool (after its heating up).

10. If the device has been unplugged, e.g. during longer breaks, the heating

up process, has to be restarted (see item 6).

11. After use unplug the welding device and let it cool down. Water must

never be used to cool the welding device, as this would destroy the

heating resistances.

12. Protect aquatherm- welding devices and tools against impurities. Burnt

particles may lead to an incorrect fusion. The tools may be cleaned with

aquatherm cleaning cloths, Art.-No. 50193.

Always keep the welding tools dry.

handle

heating plate

welding tools

13. After welding, do not lay the the device on the Teflon coated tool, but

put it down in the provided supporting stand.

14. For a perfect fusion, damaged or dirty welding tools must be replaced,

as only impeccable tools guarantee a perfect connection.

15. Never attempt to open or repair a defective device. Return the defective

device for repair.

16. Check the operating temperature of aquatherm- welding devices

regularly by means of suitable measuring instruments.