Aquatic BLUECUBE+ AQ-BC-6UBT-X Gebruikers- en installatiehandleiding - Pagina 7

Blader online of download pdf Gebruikers- en installatiehandleiding voor {categorie_naam} Aquatic BLUECUBE+ AQ-BC-6UBT-X. Aquatic BLUECUBE+ AQ-BC-6UBT-X 18 pagina's. 'hide-away' media player

Pagina afdrukken

Getting Started

BlueCube+ Media Player AQ-BC-6UBT-X

1.7 Bridge Mode

The AQ-BC-6UBT-X is capable of powering up to eight 4 Ohm speakers, however should you wish

to power a subwoofer in addition to standard speakers this can be achieved by using the two rear

speaker channels in Bridge Mode.

Cut the magenta wire to place the Bluecube+ Media Player in Bridge Mode and you will now be

able to use the left and right rear channels to power a standard passive subwoofer such as the

Aquatic AV AQ-SWP8-2.

In Bridge Mode you will only be able to power up to four 4 Ohm speakers (two from the front left

channel and two from the front right channel) plus a subwoofer.

These modifications should only be carried out by an experienced audio installer.

Should you wish to reconnect the Bridge Mode wire this can be crimped back together.

1.8 Power On

The AQ-BC-6UBT-X requires +12V DC to both the red and yellow wires. When both of these wires

have power the AQ-BC-6UBT-X is always powered on, indicated by a red LED on the heatsink of

the media player. Ground is connected to the black wire.

In a spa application this requires the red and yellow wires to be jumped together and then

connected to the +12VDC output of the power source. In this set up the AQ-BC-6UBT-X will

always be on, with a very low current draw when idle.

In a boat, ATV or other application requiring power from a battery, the yellow wire (constant

power) should be connected to the battery, and the red wire should be connected to the ignition

or a switch.

For detailed instructions you can check out our online video:

'How to wire your Aquatic AV stereo system'

http://www.aquaticav.com/support/videos