Panasonic SA-AK580 Gebruiksaanwijzing - Pagina 19

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Panasonic SA-AK580. Panasonic SA-AK580 20 pagina's. Cd stereo system
Ook voor Panasonic SA-AK580: Gebruiksaanwijzing (20 pagina's)

Pagina afdrukken

■ Unit displays

"NO PLAY"

"F61"

"ERROR"

"ERROR" (during recording)

"VBR–"

"– –:– –" (during standby

mode)

"USB OVER CURRENT

ERROR"

"HI-SPEED CAN'T REC"

"DEVICE FULL"

Memory reset (Initialisation)

When the following situations occur, refer to the instructions below to reset the memory:

• There is no response when buttons are pressed.

• You want to clear and reset the memory contents.

To reset memory

1 Disconnect the AC mains lead. (Wait at least 3 minutes before proceeding to step 2.)

2 While pressing and holding down [y/I] on the main unit, reconnect the AC mains lead.

"– – – – – – – – –" appears on the display panel.

3 Release [y/I].

All the settings are returned to the factory preset.

You will need to reset the memory items.

Maintenance

If the surfaces are dirty

To clean this unit, wipe with a soft, dry cloth.

• Never use alcohol, paint thinner or benzine to clean this unit.

• Before using chemically treated cloth, read the instructions that came with the cloth carefully.

When moving the unit

Remove all discs.

Press [y/I] to turn the unit off.

Disconnect the AC mains lead.

RQTX0271-B_GB.indd 19

• Check the content.

• Only MP3 format ﬁ les can be played.

• Disconnect the USB device. Turn the unit off and then turn back on.

Alternatively, format the USB device and record the desired tracks again and playback the

device.

• Check and correct the speaker cords connection.

If this does not ﬁ x the problem, consult the dealer.

• Disconnect the USB device. Turn the unit off and then turn back on.

• Incorrect operation performed. Read the instructions and try again.

• You are not able to select other playback source (example: radio, USB and etc.) or press

[4 / 1] or [¡ / ¢] during recording.

Stop the recording function.

• You are not able to open the disc tray when recording from AM source.

• Select a suitable recording mode (128 KBPS or 192 KBPS) and resume recording.

• The unit cannot display the remaining play time for variable bit rate (VBR) tracks.

• You plugged the AC mains lead in for the ﬁ rst time or there was a power failure recently.

• Set the time.

• The USB device is drawing too much power. Disconnect the USB device. Turn the unit off

and then back on.

• You cannot use high-speed recording while using analogue mode. Change to digital mode

or use normal recording.

• You cannot perform recording because the total USB remaining REC (recording) time of

the USB device is less than the total time of the music source.

Change to a USB device which has the appropriate recording time and perform the

recording again.

Page

—

5/6/09 11:00:30 AM