Olympus BXC-CBB Gebruiksaanwijzing - Pagina 16

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Olympus BXC-CBB. Olympus BXC-CBB 41 pagina's. Modular microscope assemblies hardware

Pagina afdrukken

3.6 Setting up BXC-CBE1

Confirm the DIP switch on BXC-CBE1 is set properly.

Set everything to OFF (factory default setting).

3.7 Attaching the objectives

Attach the objectives by screwing them into the nosepiece mounting holes.

NOTE:

Start from the nosepiece mounting hole 1 in the order of the lowest to the highest magnification objective.

Attach the objectives starting from the nosepiece mounting hole 1 without leaving any holes in between empty.

Make sure to place caps on any holes to which objectives are not attached.

3.8 Attaching the nosepiece

If you are not using the motorized nosepiece connector such as when using a manual nosepiece, refer to

motorized nosepiece connector of the motorized light guide reflected light illuminator (page

3. Setup procedures

"Storing the

13)".

3.6 Setting up BXC-CBE1